2set 7ton low emission pollute boiler in pharmaceutical factory, ZOZEN Boiler insists on developing the energy-saving technology

As a leading manufacturer of industrial boilers, ZOZEN has a network of sales around the world. Recently, ZOZEN mid-temperature and mid-pressure steam boiler project in Bangladesh was in full swing.

Recently, several WNS series gas-fired hot water boilers and steam boilers sent to Angang Group Mining Co., Ltd. have been shipped in two batches. As a leading enterprise in the domestic industrial boiler industry, ZOZEN Boiler, with the outstanding performance of eco-friendly WNS series gas-fired boiler, helps Angang Group to implement the “green steel” development concept.

ZOZEN molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

2set 7ton low emission pollute boiler in pharmaceutical factory, ZOZEN coal-fired boilers have the technical advantages of sufficient output, low emission and good energy-saving effects. They have a high degree of automation to realize the mechanization of fuel supply, ash and slag discharge. More importantly, the thermal efficiency of ZOZEN customized coal-fired boiler system is 5% higher than that of the conventional boiler system. In addition, ZOZEN coal-fired boilers have wide fuel adaptability: circulating fluidized bed boilers can be fueled by coal, gangue, refuse, and sludge; chain grate boilers can be fueled by bituminous coal, meagre coal, anthracite, which can be widely used in various industries.

The boiler hydrostatic test is a test of strength and tightness with pressurized water after the boiler or components are assembled. The main purpose of the hydrostatic test is to test the tightness and compression strength of boiler pressure-bearing components, tell whether there is leakage of welding seams, flange joints and pipe expansions, and watch the deformation conditions of pressure-bearing components with naked eyes. Practice has proved that the boiler defects can be found through the hydrostatic test, and the safety of boiler operation can be ensured after the corresponding measures are taken in time. Therefore, the hydrostatic test is an important step and means to ensure the safe boiler operation, 2set 7ton low emission pollute boiler in pharmaceutical factory.

Jindal Group is a world-renowned manufacturer and supplier of steel pipe products and fittings. With the increasing expansion of the sales network, Jindal planned to build a ductile iron pipe production plant with an annual installed capacity of 350,000 tons in Abu Dhabi, UAE, and was ready to supplement the production capacity of DI pipelines. As the thermal energy equipment of the factory, the boiler was an essential part in the construction of the factory. Jindal’s project manger learned that many Indian companies had cooperated with ZOZEN Boiler, so he immediately contacted ZOZEN Boiler. Considering that the UAE is a country with abundant natural gas resources and thereby gas-fired boiler is the preferred choice, ZOZEN finally recommended the energy-saving and eco-friendly WNS series gas-fired boiler for Jindal Group, 2set 7ton low emission pollute boiler in pharmaceutical factory.

While establishing good cooperative relations with various enterprises, ZOZEN Boiler has also contributed to the revitalization of national equipment manufacturing industry and the promotion of China from a major equipment country to a powerful equipment country. ZOZEN Boiler will continue to insist on independent innovation to drive the development, and promote the transition from “Made in China” to “Created in China”.