Continuing the 2020 industrial live streaming mode, ZOZEN Boiler has made the online visit normal. Recently, at the modern production base of Wuxi ZOZEN Boiler, technicians had connected with Finnish customers via the live streaming to show the whole process of the boiler hydrostatic test. Through the live streaming, ZOZEN not only showed the entire panorama of the hydrostatic test, but also showed the operating steps and pressure gauge values on the top of the boiler. The customers were very satisfied.
ZOZEN SZS series oil-fired/gas-fired boiler proper adopts the D-type structure. One side is the furnace, and the other side is the convection heating surface. The partition walls around the furnace body, the partition wall between furnace and convection section, and the front and rear walls all adopt the membrane wall structure. There are foreign advanced burner, economizer and condenser installed at the end of flue gas duct, which can lower the exhaust gas temperature to 60℃, achieve the thermal efficiency of over 98% and control the emission of NOx to less than 30mg/Nm3. This kind of boiler has the characteristics of energy saving and environmental protection, safety and efficiency, simple operation and maintenance, and fully automatic control system which can realize unattended operation.
The packaged structure is another characteristic of ZOZEN boiler. After the gas/oil-fired thermal oil heater is delivered to the project site, it can be put into use only by connecting the gas/oil, electricity, which can save a lot of installation costs. What's more, the boiler has the patented equipment to completely remove the moisture from the thermal oil heater after the hydraulic pressure test and reduce the oil dewatering time. Take the 6 million kcal as an example, it usually takes 10 days for oil dewatering while ZOZEN only needs 2 days, which reduces the 80% time for dewatering and directly save the costs for about 30,000 RMB.
This is ZOZEN thermal oil heater adopts the multi-circuit coil design with sufficient heating surface and good heat transfer effect which effectively protect the burner and furnace wall. The boiler adopts high-quality refractory and thermal insulation materials which can well reduce the heat loss based on the different refractory and thermal insulation structure for areas with different temperatures. In addition, based on the actual conditions, we also add the waste heat boiler, economizer, air pre-heater and other energy-saving equipment to make exhaust gas temperature to less than 90℃ and the thermal efficiency to reach over 95% and to help the enterprise reduce consumption and the costs.
ZOZEN WNS series gas/oil-fired steam boilers have outstanding eco-friendly performance. The flue gas emission of WNS series gas/oil-fired steam boilers can meet the environmental protection standards. Facing the strict low NOx emission requirements across the country, ZOZEN Boiler realizes the low emission of NOx (less than 30mg/Nm3) via the advanced low-nitrogen burner and combustion technology. ZOZEN WNS 20 tph steam boilers are applied in the food, chemical and nonferrous metal industries.
ZOZEN SZL series biomass-fired boiler has the characteristics of sufficient output and high thermal efficiency. To ensure the sufficient combustion of fuel and save the fuel costs, ZOZEN analyzes the characteristics of different fuels, and optimizes the feeding hopper, width and length of grate, grate rotating speed, secondary air inlet place and direction. ZOZEN also adopts the design of separate air chambers and air dampers to ensure the complete combustion of different biomass fuels and improve the boiler thermal efficiency to above 88%.
ZOZEN SZS series steam boiler is a kind of D-type chamber structure boiler with longitudinal double drums. It has a big combustion chamber equipped with the low emission burner to effectively reduce the NOx. It also adopts the full membrane tube wall structure and pressurized combustion without smoke mixture.
