The 3 sets of 29 MW gas-fired hot water boilers serving for Jin-an Thermal Power in Tianjin were installed in 2015. The boiler is a common type for central heating which adopts the full membrane wall structure and a D-type layout. It has the characteristics of micro-positive pressure combustion, no air leakage, low heat loss caused by exhaust gas and high thermal efficiency. During the boiler manufacturing process, ZOZEN Boiler emphasizes that the welding of each baffle must be tight, and the height of welding leg should meet the requirements specified on the design drawing to ensure the leakproofness of the boiler. In addition, ZOZEN Boiler also sets strict welding standards for detailed parts including the door opening and kiln eye to prevent the high-temperature flue gas from leaking.
The immersive foreign language training mode is a language training method with many years of practical experience and successful examples in the world. It refers to the fully enclosed language training in which the target language is used for teaching. As a learning-oriented team, ZOZEN E-commerce department used the immersive English training method. After many practices, it had effectively improved the English level of our staff to help them provide better boiler services for overseas customers.
In Sri Lanka, a set of ZOZEN 15 tph DZW series biomass-fired steam boiler was being installed and debugged. The user is a well-known local palm oil manufacturer, AEN PALM OIL PROCESSING (PVT) LTD. The boiler fuel is palm fiber. The boiler is a tri-drum boiler which has characteristics of no ash accumulation, high efficiency and good environmental protection performance. There is no need to stop the boiler for dust removal, which can make the boiler keep the normal operation for a long time. Meanwhile, considering the combustion characteristics of palm fiber, ZOZEN technicians also optimize the feeding hopper, furnace arch and air distribution device of the boiler to solve the coking problem caused by the fuel combustion.
ZOZEN SZS series oil-fired/gas-fired boiler proper adopts the D-type structure. One side is the furnace, and the other side is the convection heating surface. The partition walls around the furnace body, the partition wall between furnace and convection section, and the front and rear walls all adopt the membrane wall structure. There are foreign advanced burner, economizer and condenser installed at the end of flue gas duct, which can lower the exhaust gas temperature to 60℃, achieve the thermal efficiency of over 98% and control the emission of NOx to less than 30mg/Nm3. This kind of boiler has the characteristics of energy saving and environmental protection, safety and efficiency, simple operation and maintenance, and fully automatic control system which can realize unattended operation.
The packaged structure is another characteristic of ZOZEN boiler. After the gas/oil-fired thermal oil heater is delivered to the project site, it can be put into use only by connecting the gas/oil, electricity, which can save a lot of installation costs. What's more, the boiler has the patented equipment to completely remove the moisture from the thermal oil heater after the hydraulic pressure test and reduce the oil dewatering time. Take the 6 million kcal as an example, it usually takes 10 days for oil dewatering while ZOZEN only needs 2 days, which reduces the 80% time for dewatering and directly save the costs for about 30,000 RMB.
This is ZOZEN thermal oil heater adopts the multi-circuit coil design with sufficient heating surface and good heat transfer effect which effectively protect the burner and furnace wall. The boiler adopts high-quality refractory and thermal insulation materials which can well reduce the heat loss based on the different refractory and thermal insulation structure for areas with different temperatures. In addition, based on the actual conditions, we also add the waste heat boiler, economizer, air pre-heater and other energy-saving equipment to make exhaust gas temperature to less than 90℃ and the thermal efficiency to reach over 95% and to help the enterprise reduce consumption and the costs.
The new generation of SZL series boiler is cooperated with Shanghai Jiaotong University. It increases the furnace height, increases rotating speed, adds ash blowing device and designs ash removal system at the bottom of the grate. These well solve problems like scaling, abrasion, front arch, etc. It can also reduce the maintenance and operating costs and extend the service life of the biomass-fired boilers.
Binzhou Xinkeode Technology Co., Ltd. is a private enterprise engaged in the production and sales of neopentyl glycol, sodium formate and formaldehyde. According to the actual situation of Xinkeode’s production lines, ZOZEN Boiler recommended the SZS series gas-fired condensing boiler. This series of steam boiler adopts the large furnace design and advanced burner, which can ensure the sufficient combustion of fuel to improve the fuel use ratio. With the energy-saving equipment at the end of the gas duct, the boiler thermal efficiency can reach 98% and above to save the operating costs.
