The steam boilers in the hospital are mainly used for sterilization and have certain requirements for the quality and quantity of steam. This time, Shandong Jining Psychosis Prevention and Treatment Hospital purchased two sets of WNS series gas-fired steam boiler from ZOZEN Boiler. This series of boiler has a wide fuel adaptability including natural gas, coal gas, biogas and so on. It also adopts the large-diameter corrugated furnace to ensure the sufficient combustion of fuel and the high thermal efficiency of over 98%. Equipped with the imported low-nitrogen burner, it can easily realize the ultra low NOx emission.
SZL series vertical dual drums chain grate water tube steam and hot water boiler, adopts quick fitting and assembly structure. The 4-6t/h boiler is of quick fitting tube structure, exit shop after completely assembled, the boiler of 6-35t/h is composed of 2 main components. The upper assembled component is the boiler proper heat absorbing part, and the lower assembled component is of combustion equipment. The former part of the boiler proper is arranged a membrane wall, the upper part of it is connected to boiler cylinder, and its lower part is connected to collective chest, so as to form a combustion room and absorb the radiated heat from the furnace. Its rear part is arranged with dense convection tubes between upper and lower boiler cylinders. The high temperature smog after combustion shall stand for twice returning flushing transversely to the heat accepting surfaces, and shall be introduced to coal saver singly arranged, and flow into duster and exhausted from chimney in the end.
Thermal oil heater is a kind of new heat energy equipment with low pressure and high temperature, playing an important role in various industries. The thermal oil heater has wide adaptability of fuels, is suit for natural gas, coal gas, marsh gas, diesel, light oil, etc. The heat exchange surface adopts three-pass round coil tube structure, which features more sufficient heating surface. It is also equipped with an advanced burner to ensure the NOx emission below 30mg/m3. The waste heat boiler, air pre-heater and economizer are installed on the tails of the thermal oil heaters to effectively improve thermal efficiency, which can reach above 98%.
