This series of double-drum steam boilers adopts a full membrane wall structure with good sealing performance. It is designed with large furnace to ensure full combustion of fuel and the thermal efficiency is over 98%. Meanwhile, this series of gas-fired steam boilers has reliable water circulation. Besides, the arrangement of various safety devices such as explosion-proof doors and flame detectors make the boiler operation safer and more reliable.
ZOZEN YLW series thermal oil heater adopts the chain grate as the combustion equipment. It can provide high-temperature heat source at various temperatures below 350℃, achiving low-pressure and high-temperature heating for the processes of dyeing, drying, slashing, printing and dyeing, etc. In addition, this series of thermal oil heater realize precise temperature control through an advanced oil temperature and oil pressure control system that greatly improves heat utilization, which meets the actual needs of textile companies.
As a distinguished manufacturer of domestic industrial boiler manufacturers, in order to fully mobilize the enthusiasm of employees and improve employees' sense of belonging and identification with the company, ZOZEN E-commence Dept. will hold various type of group building activities every month to enrich employee life.
The boiler body of WNS series boilers adopts wet-back structure. The combustion, water level, temperature and steam pressure of the boiler are automatically adjusted and protected, which can realize fully automatical operation to ensure safety and reliability. The large-diameter corrugated furnace of this boiler ensures sufficient combustion of natural gas. Combined with an advanced low NOx burner, it can easily achieve the requirement of NOx≤30mg/Nm3. In addition, the boiler is also equipped with energy-saving equipment at the end of the boiler flue, so that the boiler thermal efficiency can reach over 98%.
SZL series vertical dual drums chain grate water tube steam and hot water boiler, adopts quick fitting and assembly structure. The 4-6t/h boiler is of quick fitting tube structure, exit shop after completely assembled, the boiler of 6-35t/h is composed of 2 main components. The upper assembled component is the boiler proper heat absorbing part, and the lower assembled component is of combustion equipment. The former part of the boiler proper is arranged a membrane wall, the upper part of it is connected to boiler cylinder, and its lower part is connected to collective chest, so as to form a combustion room and absorb the radiated heat from the furnace. Its rear part is arranged with dense convection tubes between upper and lower boiler cylinders. The high temperature smog after combustion shall stand for twice returning flushing transversely to the heat accepting surfaces, and shall be introduced to coal saver singly arranged, and flow into duster and exhausted from chimney in the end.
SZS series boiler is designed with longitudinal double drums and " D " type chamber structure. The furnace is on the right and convection tube bank is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler expand horizontally sideways. Around the furnace is membrane wall. Furnace and tube bundle are totally separated by the membrane wall at the left side of the furnace. The back part of convection tube bank is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, convection tube bank area, and then from left front part enters spiral fin coil economizer and condenser, and finally is discharged to atmosphere through chimney.
