Among many boiler types, biomass-fired chain grate boiler has the advantages of wide fuel adaptability, low original emission concentration, low operating costs and easy operation. Based on the eco-friendly development thinking, ZOZEN Boiler has long been designing and manufacturing the chain grate boilers. At present, the DZL series industrial boiler adopts the advanced arch design, independently developed membrane water-cooled wall structure, special slag removal technology and reasonable sealing grate structure, which shows an obvious performance advantage.
This is ZOZEN thermal oil heater adopts the multi-circuit coil design with sufficient heating surface and good heat transfer effect which effectively protect the burner and furnace wall. The boiler adopts high-quality refractory and thermal insulation materials which can well reduce the heat loss based on the different refractory and thermal insulation structure for areas with different temperatures. In addition, based on the actual conditions, we also add the waste heat boiler, economizer, air pre-heater and other energy-saving equipment to make exhaust gas temperature to less than 90℃ and the thermal efficiency to reach over 95% and to help the enterprise reduce consumption and the costs.
The new generation of SZL series boiler is cooperated with Shanghai Jiaotong University. It increases the furnace height, increases rotating speed, adds ash blowing device and designs ash removal system at the bottom of the grate. These well solve problems like scaling, abrasion, front arch, etc. It can also reduce the maintenance and operating costs and extend the service life of the biomass-fired boilers.
ZOZEN SZL series biomass-fired boiler has the characteristics of sufficient output and high thermal efficiency. To ensure the sufficient combustion of fuel and save the fuel costs, ZOZEN analyzes the characteristics of different fuels, and optimizes the feeding hopper, width and length of grate, grate rotating speed, secondary air inlet place and direction. ZOZEN also adopts the design of separate air chambers and air dampers to ensure the complete combustion of different biomass fuels and improve the boiler thermal efficiency to above 88%.