zozen boiler
HomeBoiler tagsheating boiler

“heating boiler”- related faq

  • Why is the chain grate stuck and stopped during the operation of coal-fired boilers? 2023-01-28
    Question details (Performance) : 1. The vibrating coal grate stops running totally or intermittently. 2. The current of vibrating coal grate motor rises abnormally. 3. The safety clutch of transmission machine of grate or safety pin is broken.   Answer: cause of the problem: Boiler’s vibrating coal grate is a rotating combustion equipment, due to the bad working conditions, stuck stalling is easily happened and grate failure happens in daily application and ...
  • What are the interlocks for a steam boiler? 2022-12-23
    An Interlock in the boiler’s control system is a programmed or hardwired condition that forces a device to be in a pre-determined or permissive state before the process can continue. Depending on design pressure, fuel type, either liquid, gas or solid, all steam boiler require interlocks to sequence the operation and to prevent damage to the boiler. Examples of such devices are High or Low Boiler Drum Water Level, Low Boiler Feed Pump Pressure, High or Low Fuel pressure, High or Low Atomization pressure (oil fired), Proof of Ignition, Proof of Flame, FD and/or ID (solid fuel) Fan Motor Operation or combustion air pressure, Damper or Valve position and High Boiler Steam Pressure as well as O2 and furnace temperature.
  • What is the tph meaning in boiler? 2022-12-23
    Definition of the tph meaning in boiler When a steam boiler is continuously operated for a long period of time, the amount of steam generated per hour is called the evaporation amount of this boiler, and is usually used in tons per hour (t/h or tph). A steam boiler is a steam device that uses heated energy or other thermal energy that is converted by the combustion of a fuel to heat the feed water to obtain specified parameters (temperature, pressure) and quality. 1tph means that the boi...
  • Why are boiler manholes elliptical in shape? 2022-12-23
    The boiler manhole-lids are mounted from the inside of the boiler so that the boiler pressure will help to keep them tight. Hence the manholes have to be elliptical in shape to make it possible to take the lid out from the boiler.
  • Where is the appropriate place to install the gas boiler in the boiler room? 2022-11-25
    The design and construction of gas boiler room is also a very important point in boiler safety. How to install the gas boiler should also conform to the boiler room design specification, and it is necessary to comply with the site, space, protection and other aspects.   How to install the gas boiler? How to install the gas boiler is mainly based on the Boiler Room Design Code and Boiler Safety Technical Inspection Code. In addition, the Urban Gas Design Code and the Fire Protection Code ...
  • What is the hardness of condensate water from gas boiler flue gas? 2022-11-25
    As a clean fuel, natural gas has much lower sulfur content and nitrogen content than coal, and there is no ash in the fuel, and the flue gas produced after combustion is almost smoke-free. Therefore, a nationwide upsurge of coal to gas has been set off.   However, there are some problems in the process of gas boiler operation, among which the hardness, harm and treatment of gas boiler flue gas condensate are prominent.   When the boiler flue gas temperature is lower than the dew po...
  • What is the heating medium of the boiler? 2022-11-25
    The main working principle of industry is a kind of heating equipment which uses the heat energy released after fuel combustion or the waste heat in industrial production to transfer to the medium in the container, so that the medium can reach the required temperature, and then it can be transported to the heating process for heat exchange. According to different media, boilers can be divided into many types.   Types of boiler heating medium 1. Steam, steam boiler and superheated steam b...
  • What are the precautions for long-term work in the boiler room? 2022-11-25
    Precautions for long-term work in the boiler room 1. Standard setting. Nowadays, most boilers are operated by PLC control system. Therefore, when setting, the boiler should be operated according to the factory instructions, so that the boiler can work within the required range. 2. Water level and water quality. Check whether the boiler water supply facilities are normal and whether the boiler water level meets the requirements. In addition, check whether the water quality is up to standard and...
1...7 8 9 10 11 12 13 14...82