ZOZEN Boiler cooperated with Hebei Yigao Bioenergy Co., Ltd. to improve the reasonable and efficient utilization of biomass energy such as corn straws and so on. According to Hebei Yigao Bioenergy’s requirement of using biomass straws as fuel, ZOZEN Boiler reasonably designed the furnace arch, furnace wall and furnace heating surface of SZL series biomass-fired steam boiler by cooperating with Shanghai Jiaotong University to ensure the combustion efficiency and rated evaporation capacity of boiler.
In response to increasingly serious environmental problems, Ji Xiang Ju Food decides to purchase low NOx and eco-friendly gas-fired steam boiler. To meet the new requirements, ZOZEN Boiler customizes the boiler system and recommends SZS series low NOx steam boiler to ensure the sufficient heat supply for Ji Xiang Ju Food's production line. This series of gas-fired boiler adopts D-model full membrane wall structure and combustion chamber adopts narrow-spacing tube membrane wall with good air impermeability to reduce heat loss and enhance the thermal efficiency to 98% and above with the economizer at the end of flue gas duct.
Recently, ZOZEN took a field trip at the project location of the WNS boiler. The ZOZEN WNS series gas-fired steam boilers are horizontal wetback fire-tube boilers which have reasonable internal structure. An advanced low NOx burner is equipped with the boiler to reduce the NOx emission to less than 30mg/Nm3. At the same time, the burner can realize automatic air adjustment, which can ensure the sufficient fuel combustion.
Bolivia is the highest average altitude country in the world, local Bolivian companies have higher requirements for boilers than general boilers. As the altitude increases, the atmospheric pressure and the air density decrease accordingly, which adversely affects boiler combustion.
In view of this situation, ZOZEN technical team makes adjustments from the combustion system and exhaust system of boiler, fully considering the influence of low air pressure on boiler body design and combustion. By appropriately increasing the volume of the furnace to extend the residence time of the fuel in the furnace, and the problems of slow fuel burning speed and long burning time are solved.
This series of double-drum steam boilers adopts a full membrane wall structure with good sealing performance. It is designed with large furnace to ensure full combustion of fuel and the thermal efficiency is over 98%. Meanwhile, this series of gas-fired steam boilers has reliable water circulation. Besides, the arrangement of various safety devices such as explosion-proof doors and flame detectors make the boiler operation safer and more reliable.
SZL series vertical dual drums chain grate water tube steam and hot water boiler, adopts quick fitting and assembly structure. The 4-6t/h boiler is of quick fitting tube structure, exit shop after completely assembled, the boiler of 6-35t/h is composed of 2 main components. The upper assembled component is the boiler proper heat absorbing part, and the lower assembled component is of combustion equipment. The former part of the boiler proper is arranged a membrane wall, the upper part of it is connected to boiler cylinder, and its lower part is connected to collective chest, so as to form a combustion room and absorb the radiated heat from the furnace. Its rear part is arranged with dense convection tubes between upper and lower boiler cylinders. The high temperature smog after combustion shall stand for twice returning flushing transversely to the heat accepting surfaces, and shall be introduced to coal saver singly arranged, and flow into duster and exhausted from chimney in the end.
SZS series boiler is designed with longitudinal double drums and " D " type chamber structure. The furnace is on the right and convection tube bank is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler expand horizontally sideways. Around the furnace is membrane wall. Furnace and tube bundle are totally separated by the membrane wall at the left side of the furnace. The back part of convection tube bank is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, convection tube bank area, and then from left front part enters spiral fin coil economizer and condenser, and finally is discharged to atmosphere through chimney.
