SZL series vertical dual drums chain grate water tube steam and hot water boiler, adopts quick fitting and assembly structure. The 4-6t/h boiler is of quick fitting tube structure, exit shop after completely assembled, the boiler of 6-35t/h is composed of 2 main components. The upper assembled component is the boiler proper heat absorbing part, and the lower assembled component is of combustion equipment. The former part of the boiler proper is arranged a membrane wall, the upper part of it is connected to boiler cylinder, and its lower part is connected to collective chest, so as to form a combustion room and absorb the radiated heat from the furnace. Its rear part is arranged with dense convection tubes between upper and lower boiler cylinders. The high temperature smog after combustion shall stand for twice returning flushing transversely to the heat accepting surfaces, and shall be introduced to coal saver singly arranged, and flow into duster and exhausted from chimney in the end.
SZS series boiler is designed with longitudinal double drums and " D " type chamber structure. The furnace is on the right and convection tube bank is on the left. The body is fixed on the basement by middle and both end flexible supports and make the boiler expand horizontally sideways. Around the furnace is membrane wall. Furnace and tube bundle are totally separated by the membrane wall at the left side of the furnace. The back part of convection tube bank is sparse shift structure, front part is aligned structure. Smoke from furnace outlet enters re-burning chamber, convection tube bank area, and then from left front part enters spiral fin coil economizer and condenser, and finally is discharged to atmosphere through chimney.
WNS series horizontal internal combustion boiler is a boiler shell type 3 passes wetback oil/gas fired boiler. After fuel is being atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall, this is 1st pass; the high temperature smoke is collected in reversal chamber and then enters 2nd pass which is grooved tubes bundle area; after heat convection, air temperature gradually falls and goes to front smoke box and turn to 3rd pass, which is smooth tubes bundle area, and then enters chimney passing back smoke box and exhausted to the atmosphere.
The body and the middle partition wall of ZOZEN DHL series corner tube hot water boiler adopt membrane water wall complete sealing structure, which greatly reduces the boiler heat loss and improves the boiler thermal efficiency. Meanwhile, the flag heating surface of this series of boilers is designed with patented technology of the same smoke velocity in variable cross-section, so that the flow velocity of the smoke in heated surface between the high temperature zone and the low temperature zone is uniform, reducing the ash accumulation and increasing the heat transfer co-efficiency. In addition, the water circulation structure of DHL series coal-fired boilers is identified the first domestic product in China due to its reliability and advancement. It is widely used because its comprehensive performance has exceeded similar products on the market.
ZOZEN engineer viewed the internal operation of the boiler from the observation hole;
Observed the running condition of the boiler from the outside;
Checked the external equipment of the boiler.
