steem boiler sales, ZOZEN boiler actively responds to environmental protection initiatives and promotes the green products

Winter is officially here! When cold weather settles in, it is important to make sure that your boiler is well-maintained. Like any other mechanical system, boilers will tend to wear down over time. Boilers can be dangerous if not properly inspected and not working properly. Full boiler efficiency will help avoid boiler downtime and unnecessary expenses. Here are 14 steps to follow to help you get on track with your winter maintenance.

ZOZEN DHL corner tube hot water boiler for China Medical University

steem boiler sales, From November 15 to 17, 2020 China Aerated Concrete Industry Conference and the 40th Association Annual Meeting was held in Chongqing. As a boiler equipment supplier with outstanding performance in the aerated concrete industry, Wuxi ZOZEN Boilers Co., Ltd. sent the representative to participate in the event.

ZOZEN service engineer monitored the data of boiler

steem boiler sales, The SZS series gas-fired steam boiler produced by ZOZEN Boiler adopts the D-type and full membrane wall structure. The large furnace space ensures the sufficient combustion of the fuel and has good gas tightness. Meanwhile, the furnace body is made of high-quality aluminum silicate fiber and refractory mud for insulation to control the furnace body temperature below 45℃ and control the heat loss; with the additional energy-saving device at the end of the flue gas duct, the boiler thermal efficiency can be improved to more than 98%.

ZOZEN SZS series boiler body is designed with D-type chamber combustion structure. The furnace is on right side and the convection heating surface is on left side. The membrane type structure is adopted for the circumference of the furnace body, the wall between the furnace and the convection zone, the front and rear walls of boilers body. The furnace pressure is designed to be greater than 6000Pa.

steem boiler sales, The boiler hydrostatic test is a test of strength and tightness with pressurized water after the boiler or components are assembled. The main purpose of the hydrostatic test is to test the tightness and compression strength of boiler pressure-bearing components, tell whether there is leakage of welding seams, flange joints and pipe expansions, and watch the deformation conditions of pressure-bearing components with naked eyes. Practice has proved that the boiler defects can be found through the hydrostatic test, and the safety of boiler operation can be ensured after the corresponding measures are taken in time. Therefore, the hydrostatic test is an important step and means to ensure the safe boiler operation.

In order to meet the requirements of energy saving, environmental protection and sustainable development, Hubei Guoan Energy Power Equipment Engineering Co., Ltd. needed to purchase eco-friendly gas-fired boilers. After learning about the outstanding comprehensive competitiveness and good market reputation of ZOZEN Boiler, it reached the cooperation with ZOZEN Boiler. According to the actual demands of Hubei Guoan, ZOZEN Boiler recommended the SZS series condensing gas-fired boiler. This type of steam boiler adopts the large-volume furnace and advanced burner to ensure the sufficient fuel combustion and improve the fuel utilization. With the energy-saving devices added at the end of the flue gas duct, the boiler thermal efficiency can reach more than 98%, so as to save the operating costs.

As a well-known boiler brand, ZOZEN Boiler has always insisted on providing every customer with the full-process tracking service from boiler design, manufacture, commissioning to actual application. Afterwards, ZOZEN Boiler will continue to adhere to the full-process, full-day, full-aspect and full-spirit service principle to help Hebei Yigao Biotech complete the environmental assessment and contribute to dealing with the environmental pollution problems.