Chain grate boiler is a very mature boiler type, which has the characteristics of simple operation and management and easy mastering, and is widely used in various industries.
1. Enterprise qualification
Which manufacturer is good, enterprise qualification is the first. On the whole, enterprise qualification reflects the enterprise's personnel quality, technology and management level, engineering equipment, capital and benefit, contract management ability and other aspects. Genera...
The boiler needs to blow off every day, and it is advisable to reduce the blowdown to below the boiler water level every time.
The boiler water level meter can record the boiler water level in detail, and the water level has a great influence on the boiler, so we should ensure that the boiler water level is within the normal range.
When the gas-fired boiler is running, there will be pressure inside, which can provide sufficient power for all kinds of production equipment. However, if the press...
How to select the right thermal fluid heater for your plant can be a tough task. With so many industrial heating equipment manufacturers and heater models on the market, it can be difficult to narrow down your options and make a decision.
It’s probably going to be tough to focus your full, uninterrupted attention on the task of choosing a new industrial thermal fluid heater for a long stretch of time. You’re going to need to make the best decision possible for your plant qui...
The primary use of steam boiler in tire manufacturing is the vulcanizing process — the curing of the rubber needs steam to provide heat energy. Curing is a process in which chemical or physical action takes place for harder, tougher and more stable linkage.
As we know tires are the most important part of our vehicle because in all the parts of vehicle tires only remain in contact with the earth hence tires carry all the load of vehicle and passengers.
Vulcanization is a p...
The term Thermal Fluid does not refer to a specific fluid, there are many. There are also many companies that produce a variety of Thermal Fluids.
The most common Thermal Fluids are either Mineral Oil based or Synthetic Oils. The various manufacturers typically produce a series of fluids that each has a recommended operating temperature range. Close consideration should be given to this operating range in selecting a fluid.
There are other considerations as well, consult with f...
Coal-fired boilers refer to boilers that use various kinds of coals as fuel and convert the heat value of coals to steam or hot water.
Some specific parameters should be provided to calculate the theoretical coal consumption of a set of 20 tph coal-fired boiler. If the rated steam pressure is 1 MPa, the heat value of coal is 7000 kcal / kg, the boiler inlet water temperature is 20 ° C, and the boiler thermal efficiency is 80%, the daily coal consumption is 50-56 tons.
1. Your existing system is inefficient
Efficiency is key when it comes to plant heating. Utilizing efficient equipment can save your company a significant amount of money in the long run and it is better for the environment. If you know that your existing system is not as efficient as it could be and it is in need of repair, it may be worth looking into thermal oil system replacement.
2. Your existing system features helical coil technology
Helical coils are common in thermal oil heaters from most manufacturers. But there are many reasons why serpentine coils are the better way to go when it comes to thermal fluid heating. Repairs to helical coils can be so expensive and time consuming that in many cases you are better off investing in new equipment – and it is well worth it to consider a new thermal oil system that features serpentine coil technology instead.
