If the electric current of the circulating pump in a thermal oil heater is lower than the normal value, it may indicate a problem with the pump or the system. Here are some potential causes and solutions:
1. Low fluid level: If the thermal oil level is low, the pump may not be able to circulate the oil properly, leading to lower current readings. Check the fluid level and add more oil if necessary.
2. Clogged filter: A clogged filter can restrict the flow of thermal oil, causing the pump to wo...
Load tracking is an important feature of industrial boilers that helps to optimize their performance and efficiency. Load tracking refers to the ability of a boiler to adjust its output in response to changes in demand.
In an industrial setting, the demand for steam or hot water can vary significantly depending on factors such as production schedules, weather conditions, and other variables. Load tracking allows the boiler to adjust its output to match the changing demand, ensuring that...
High exhaust temperature in a biomass-fired boiler can be caused by several factors, including:
1. Insufficient air supply: If there is not enough air supplied to the combustion chamber, the fuel may not burn completely, resulting in high exhaust temperatures.
2. Excessive fuel supply: Excessive fuel supply can overload the boiler, causing incomplete combustion and high exhaust temperatures.
3. Improper combustion: Improper combustion can lead to incomplete fuel burning and high exhaust tempe...
Regular maintenance is essential to ensure safe and efficient operation of industrial thermal oil heaters. Here are some of the key maintenance tasks that should be performed:
1. Daily checks: The operator should perform daily checks of the heater, including checking the fuel level, the temperature of the thermal oil, and the pressure of the system.
2. Cleaning: The heater should be cleaned regularly to remove any buildup of soot, ash, or other debris that can reduce efficiency or cause damage...
Thermic fluid heater boilers are widely used in a variety of industries because of their excellent performance and energy efficiency. They offer several benefits over traditional steam boilers, including better temperature control, easy operation, and low maintenance costs. Here are some frequently asked questions about thermic fluid heater boilers:
1, What is a thermic fluid heater boiler?
A thermic fluid heater boiler is a device that uses thermal oil or heat transfer oil to transfer heat fr...
An Interlock in the boiler’s control system is a programmed or hardwired condition that forces a device to be in a pre-determined or permissive state before the process can continue.
Depending on design pressure, fuel type, either liquid, gas or solid, all steam boiler require interlocks to sequence the operation and to prevent damage to the boiler. Examples of such devices are High or Low Boiler Drum Water Level, Low Boiler Feed Pump Pressure, High or Low Fuel pressure, High or Low Atomization pressure (oil fired), Proof of Ignition, Proof of Flame, FD and/or ID (solid fuel) Fan Motor Operation or combustion air pressure, Damper or Valve position and High Boiler Steam Pressure as well as O2 and furnace temperature.
1. After boiler body, economizer, air pre-heater, dust collector, etc are in place and installed, connect FD fan, ID fan, etc according to drawing and then connect corresponding flue gas duct. After fan in place, alignment between foundation and equipment base should be conducted with parallels. Fan position alignment should center on a shaft, central elevation deviation and vertical and lateral central line positional deviation should be 10mm or less and fan spindle should be in level state. Th...
The flue gas treatment of biomass boiler adopts the pretreatment and deep processing. The deep processing adopts the pulsed jet cloth filter, the waste gas treated by this system can meet the discharge standard stably. The flue gas enters the cyclone dust collector or flame arrestor through the dust removal pipeline.
