ZOZEN SZS series oil-fired/gas-fired boiler proper adopts the D-type structure. One side is the furnace, and the other side is the convection heating surface. The partition walls around the furnace body, the partition wall between furnace and convection section, and the front and rear walls all adopt the membrane wall structure. There are foreign advanced burner, economizer and condenser installed at the end of flue gas duct, which can lower the exhaust gas temperature to 60℃, achieve the thermal efficiency of over 98% and control the emission of NOx to less than 30mg/Nm3. This kind of boiler has the characteristics of energy saving and environmental protection, safety and efficiency, simple operation and maintenance, and fully automatic control system which can realize unattended operation.
The packaged structure is another characteristic of ZOZEN boiler. After the gas/oil-fired thermal oil heater is delivered to the project site, it can be put into use only by connecting the gas/oil, electricity, which can save a lot of installation costs. What's more, the boiler has the patented equipment to completely remove the moisture from the thermal oil heater after the hydraulic pressure test and reduce the oil dewatering time. Take the 6 million kcal as an example, it usually takes 10 days for oil dewatering while ZOZEN only needs 2 days, which reduces the 80% time for dewatering and directly save the costs for about 30,000 RMB.
This is ZOZEN thermal oil heater adopts the multi-circuit coil design with sufficient heating surface and good heat transfer effect which effectively protect the burner and furnace wall. The boiler adopts high-quality refractory and thermal insulation materials which can well reduce the heat loss based on the different refractory and thermal insulation structure for areas with different temperatures. In addition, based on the actual conditions, we also add the waste heat boiler, economizer, air pre-heater and other energy-saving equipment to make exhaust gas temperature to less than 90℃ and the thermal efficiency to reach over 95% and to help the enterprise reduce consumption and the costs.
This is gas-fired/oil-fired thermal oil heater from ZOZEN Boiler which is widely used in petroleum, chemical fiber, pharmaceutical, printing and dyeing and other industries that require high-temperature heating. The thermal oil heater adopts heat medium oil to transfer the heat energy. Applying high temperature of heat medium oil, the boiler can realize low pressure and high temperature heating with a working temperature of 320℃. Meanwhile, our thermal oil heater is equipped with the complete device for operation control and safety supervision which can precisely control the working temperature with convenient operation and high safety performance.
The new generation of SZL series boiler is cooperated with Shanghai Jiaotong University. It increases the furnace height, increases rotating speed, adds ash blowing device and designs ash removal system at the bottom of the grate. These well solve problems like scaling, abrasion, front arch, etc. It can also reduce the maintenance and operating costs and extend the service life of the biomass-fired boilers.
ZOZEN WNS series gas/oil-fired steam boilers have outstanding eco-friendly performance. The flue gas emission of WNS series gas/oil-fired steam boilers can meet the environmental protection standards. Facing the strict low NOx emission requirements across the country, ZOZEN Boiler realizes the low emission of NOx (less than 30mg/Nm3) via the advanced low-nitrogen burner and combustion technology. ZOZEN WNS 20 tph steam boilers are applied in the food, chemical and nonferrous metal industries.
ZOZEN SZL series biomass-fired boiler can be fired by various kinds of fuel including biomass particles, wood chips, palm shells, straws and so on. The boiler body is composed of the chain grate and boiler proper with a packaged or pre-assembled structure. It is convenient for installation, so it can reduce the basic construction costs for customers. At the same time, in order to meet the boiler emission standards in different areas, ZOZEN Boiler can design the cyclone, wet scrubber and bag-type dust removal devices to lower the NOx emission to 200mg/m3.
