A condensing boiler can condense the water vapour in the flue gases and withstand the corrosive and acidic qualities of the flue gas condensate. Although most boilers can condense the flue gasses, only boilers that have heat exchangers constructed from materials able to withstand the corrosion should be used in condensing application. Condensing boilers with primary and secondary heat exchanger do not work well as they are not able to fully condense and defeat the purpose of using a condensing boiler. Also, boilers with this arrangement are prone to condensation in the primary heat exchanger at lower firing rate which can cause damage to the heat exchanger.
Three-pass steam boilers are so-called because the combustion gases that are produced inside them in the burner go round a circuit that has three parts before leaving it:
Nox is the generic term for a group of highly reactive gases, all of which contain nitrogen and oxygen in varying amounts. Many of the nitrogen oxides are colorless and odorless. However, one common pollutant, nitrogen dioxide (NO2) along with particles in the air can often be seen as a reddish-brown layer over many urban areas.
Nox forms when fuel is burned at high temperatures, as in a combustion process. The primary sources of Nox are motor vehicles, electric utilities, and other industrial,...
Whether it's an industrial hot water boiler or an industrial steam boiler, they all depend on fuel to run. The process of heating is initiated as the burner heats or eventually evaporates the water inside of it. It's actually transported via intricate pipe systems.
Steam boilers transport through the pressure created by the process, while hot water boilers use pumps to move heat throughout the system. Eventually the condensed steam or cooled water returns back through the pipes to the boiler system, so the heating process can be initiated again.
As the boiler creates heat energy, a byproduct of the process — flue gases — are exited through a chimney system. Because of this, regulating the industrial boiler emissions is a very serious issue.
The efficiency of a coal-fired boiler depends on the loss of the boiler, the best efficiency in the boiler can be achieved if the losses are kept to the minimum. Since 50% of the losses are dependent on the fuel and ambient condition, the best efficiency can be achieved by properly tuning the other 50%, i.e. mainly carbon loss and dry gas loss.
The answer is yes. The bagasse boiler is a distinctive biomass boiler. According to its specific application, it can also be said to be a bagasse biomass power generation boiler. The bagasse boiler is mainly used for power generation, especially large-scale bagasse biomass boiler equipment, such as 75 tons/hour bagasse power generation boiler, 150 tons bagasse boiler, and 180 tons power generation boiler.
As we all know, the stable operation of the natural gas boiler can significantly optimize the operation of the boiler, improve the efficiency of the boiler, and effectively reduce the operating cost of the boiler after effective maintenance. So, what factors will affect the stable operation of natural gas boilers?
Gas consumption per hour of natural gas boiler = boiler thermal efficiency / natural gas calorific value / boiler efficiency. The higher the efficiency of boiler use, the less gas consumption, which has inverse relationship between the two. Boiler efficiency has become a key point in assessing boiler quality.
