A steam generator is a mechanical equipment that uses the heat energy of fuel or other energy resources to heat water into hot water or steam. It belongs to small equipment and is a kind of steam boiler. According to Boiler Safety Technical Inspection Regulations, a boiler whose water volume exceeds 30 litres belongs to pressure container, national special equipment. There is no need of water storage in the internal structure of modular steam generator concurrent pipeline and the water volume is...
Whether it's an industrial hot water boiler or an industrial steam boiler, they all depend on fuel to run. The process of heating is initiated as the burner heats or eventually evaporates the water inside of it. It's actually transported via intricate pipe systems.
Steam boilers transport through the pressure created by the process, while hot water boilers use pumps to move heat throughout the system. Eventually the condensed steam or cooled water returns back through the pipes to the boiler system, so the heating process can be initiated again.
As the boiler creates heat energy, a byproduct of the process — flue gases — are exited through a chimney system. Because of this, regulating the industrial boiler emissions is a very serious issue.
The answer is yes. The bagasse boiler is a distinctive biomass boiler. According to its specific application, it can also be said to be a bagasse biomass power generation boiler. The bagasse boiler is mainly used for power generation, especially large-scale bagasse biomass boiler equipment, such as 75 tons/hour bagasse power generation boiler, 150 tons bagasse boiler, and 180 tons power generation boiler.
Due to the development of boiler technology and relevant policies, gas-fired boilers using eco-friendly fuels are often applied for heating. For thermal power companies, cost is the most important issue.
The thermal oil heater, also called organic heat carrier boiler, provides heat energy for production by heating the heat medium oil. It can realize the high-temperature and low-pressure heating without constant water supply. What are the characteristics of the thermal oil heater?
The exhaust gas heat loss of coal-fired boiler is caused by the flue gas removed by final stage heat exchanger. The flue gas will take away a part of heat, mainly including the heat taken away by dry flue gas and the sensible heat with water vapor in the flue gas. What’s more, if the combustible gas in the coal-fired boiler is not completely burned, there will be heat loss as well. Therefore, this kind of heat loss mainly depends on the content of incomplete combustion products in the exhaust smoke.
Normally a boiler is provided with two independent sensors for emergency low water level burner cut-outs. So this would never happen. However, if it does, don't take any chances! Shut off the burners immediately!
Before you start raising the level in the boiler you have to find out if any part of the furnace walls has been overheated. If you raise the level over a glowing steel-wall then the boiler might produce more steam than the safety valves can handle and a nasty explosion would be the result.
If the final temperature of feed water doesn’t reach the saturated temperature after being heated by an economizer, (that is, the feed water has not reached the boiling state), we call the economizer as a nonsteaming economizer. Generally, the final temperature is 30-50℃ lower than the saturated temperature.
