Steam boilers use a contained heat system to generate steam. The steam travels through pipes in the building’s walls where they emerge at radiators in heating systems. The radiators warm from the steam’s heat. As the steam gives off its heat, it condenses back to liquid water and returns to the tank. A boiler system of this type that does not allow outside water sources is a closed system and is highly efficient for using all the condensed water. An open network may be required in operations where the steam or water gets contaminated in such a way that it cannot return to the boiler for reuse.
The special spray gun for pulverized coal boilers is a kind of equipment that atomizes fuel oil (light oil, heavy oil, residual oil, etc.) to make the fuel oil into UM-level particles. Through air distribution and ignition, the fuel oil can be sufficiently burned. It is widely used in the boiler industry.
The automatic boiler water level controller is mainly composed of hardware and software parts to complete the functions of the control system. The hardware part is mainly composed of the water level detection circuit, drive circuit, water level indication circuit, pressure automatic control simulation, manual control, etc. The software part is mainly composed of the programs written in assembly language.
According to the power of water or steam circulation, boilers can be divided into natural circulation boilers, forced circulation boilers, once-through boilers and combined circulation boilers.
The hot medium oil of the thermal oil heater should be tested regularly to measure and analyze the physical and chemical indicators such as the residual carbon, acid value, viscosity, flash point, melting point and so on, so as to know the quality changes in time and analyze the reasons for the changes. When the acid value exceeds 0.5mgKOH/g, the viscosity change reaches 15%, the flash point change reaches 20%, and the residual carbon (mass fraction) reaches 1.5%, it indicates that the performance of the hot medium oil has changed. Therefore, the user needs to regularly add the new heat carrier when using the hot medium oil to keep the residual carbon in the system stable.
The gas-fired boiler has the wonderful energy-saving effect and environmental protection performance. The energy-saving effect of the gas-fired boiler is realized by many boiler parts.
As the state environmental protection requirements become more and more strict, there are also relevant regulations and standards for boiler pollutant discharge. As a result, what is the sequential process of desulfurization and denitrification for the coal-fired boiler?
1) Set up the air preheater. One of the most effective measures to improve the thermal efficiency of thermal oil heater is to use an air preheater for heat recovery. 2) Use waste heat boiler for heat recovery. The waste heat boiler uses the waste heat in the flue gas exhausted from the thermal oil heater to heat water or generate steam.
