When it comes to coal fired boilers, the rear arch plays a critical role in the combustion process. The main function of the rear arch is to keep the fuel particles in suspension and prevent them from falling into the ash hopper, which can lead to incomplete combustion and decreased efficiency.
At ZOZEN, we understand the importance of a well-designed rear arch for coal fired boilers. That's why our coal fired boilers are equipped with advanced rear arch designs that enhance the combust...
Combustion is a process which needs constant air supply for its survival, but as we move up the earth i.e. at higher altitudes, things aren’t the same as they used to be at sea level. Due to decreased air density at higher altitude, it will consume the same volume of air but will not consume the same mass of air.
This results in less fuel consumption & less steam generation rate. Due to the reduction of mass flow of gases through tubes of a steam boiler, convective heat transf...
As their name implies, hot water boilers operate by being completely filled with hot water. On the other hand, steam boilers are usually only filled approximately 3/4th of the way full, while the top quarter is reserved for steam.
Facing the aggravation of environmental pollution, many industries have been required to meet the pollutant emission standards. As a kind of thermal energy equipment, the boiler has high pollutant emission. However, the implementation of environmental protection policies has prompted enterprises to use energy-saving and eco-friendly boilers. Therefore, let us talk about the characteristics of the gas-fired condensing boiler here.
The condensing boiler burns carbon-based fuel with oxygen in order to produce steam and carbon dioxide. The gases that escape this process (through a chimney) as exhaust are called flue gases. The major advantage is that they offer up to a 90% improvement in terms of efficiency when compared to standard gas boilers. Overall, condensing boilers are considered much more efficient in contrast to non-condensing gas boilers, a major consideration for any business running on a budget.
If the following three conditions occur during the burning and flame out process of a gas-fired boiler, the furnace is likely to blow up.
1.The residual gas content in the furnace reaches the ignition limit at the start-up phase of the furnace.
2.The fuel content in the furnace reaches the ignition limit after several times failure of ignition.
3.The fuel is sprayed out because of the halfway extinction of the flame. And, the temperature of the furnace can not meet the spontaneous combustion condition of the sprayed fuel. However, the content of the sprayed fuel reaches the ignition limit.
The inlet gas pressure is different for different capacity boiler, for example, the pressure for 2 ton steam capacity boiler is about 8~10KPa, while for 4 ton steam capacity boiler is about 12~25KPa. You can tell us the boiler capacity you want, we will help you to get the gas inlet pressure.
Coal-fired boilers refer to boilers that use various kinds of coals as fuel and convert the heat value of coals to steam or hot water.
Some specific parameters should be provided to calculate the theoretical coal consumption of a set of 20 tph coal-fired boiler. If the rated steam pressure is 1 MPa, the heat value of coal is 7000 kcal / kg, the boiler inlet water temperature is 20 ° C, and the boiler thermal efficiency is 80%, the daily coal consumption is 50-56 tons.