If you notice water dripping from a gas-fired boiler's chimney, it could be due to condensation, which is a common issue in high-efficiency boilers. Here are some key reasons and explanations for this phenomenon:
Condensation of Flue Gases: Modern high-efficiency gas boilers are designed to extract as much heat as possible from the combustion gases before they are expelled through the chimney. This process can cool the gases to a point where the moisture in them condenses into water. This is mo...
If the burner motor of a gas-fired boiler is running and voltage is present at the controller terminal, but there is no ignition followed by a system failure and stop, this situation can be attributed to several potential issues. Here's a breakdown of what might be happening and what to check:
Ignition System Failure: The ignition system, which may include spark electrodes or an igniter, could be faulty. Check for any signs of damage, misalignment, or dirt on the igniter or electrodes.
Control...
If the burner motor of a gas-fired boiler is not running, several issues could be at play. Diagnosing the problem involves checking various components and systems. Here are some common causes:
Electrical Issues: Check if there's an electrical supply to the motor. A tripped circuit breaker, blown fuse, or loose wiring could interrupt power supply to the motor.
Faulty Motor: The motor itself could be malfunctioning. Over time, motors can wear out or burn out due to electrical issues or mechanica...
Overheating in the combustion engine of a gas-fired boiler can be caused by several factors. Understanding and addressing these issues is crucial for maintaining the efficiency and longevity of the boiler, as well as for ensuring safety. Here are some common causes of overheating in the combustion engine of a gas-fired boiler:
Insufficient Water Flow: If there isn't enough water flowing through the boiler, it can't absorb enough heat from the combustion process, leading to overheating. This cou...
There are several ways to estimate the thermal efficiency of gas-fired boilers:
1. Direct method: This method involves measuring the amount of fuel consumed and the amount of heat produced by the boiler. By comparing these two values, it is possible to calculate the thermal efficiency of the boiler.
2. Indirect method: The indirect method involves measuring various parameters such as flue gas temperature, ambient air temperature, and fuel consumption, and then calculating the t...
Gas-fired boilers use gaseous flammable gases (including liquefied combustible gases) as fuel. These gaseous fuels have relatively higher calorific value and less pollutant emissions, and are gradually becoming popular among corporate users.
Biomass boilers do produce emissions when they burn organic materials such as wood chips, pellets, or agricultural waste. The exact type and amount of emissions depend on various factors such as the type of fuel used, combustion efficiency, and air pollution control technologies in place. However, with proper design and operation, biomass boilers can emit significantly less pollutants than traditional fossil fuel boilers, making them a more environmentally friendly option for heat and power...
An Interlock in the boiler’s control system is a programmed or hardwired condition that forces a device to be in a pre-determined or permissive state before the process can continue.
Depending on design pressure, fuel type, either liquid, gas or solid, all steam boiler require interlocks to sequence the operation and to prevent damage to the boiler. Examples of such devices are High or Low Boiler Drum Water Level, Low Boiler Feed Pump Pressure, High or Low Fuel pressure, High or Low Atomization pressure (oil fired), Proof of Ignition, Proof of Flame, FD and/or ID (solid fuel) Fan Motor Operation or combustion air pressure, Damper or Valve position and High Boiler Steam Pressure as well as O2 and furnace temperature.
