high safety and high efficiency hot water boiler, the intelligent equipment of ZOZEN boiler has a leading advantage in china

high safety and high efficiency hot water boiler, With emission requirements changing every day, it is also important to make sure that you are proactive when selecting equipment that will comply with future air regulations. Zozen Boiler has the most experience in selecting boiler equipment that will meet current and future NOx requirements.

ZOZEN SHX series CFB boiler, evaporation capacity from 10- 75 tph, with steam pressure 1.25-2.5 Mpa and the steam temperature is saturated steam and superheated steam. Hot water boiler 7-58 MW, supplies 130℃/150℃ hot water. Under pressure of 1.0-1.6 Mpa, the returning water temperature is 70℃/90℃. CFCB technology is a new type and mature high efficient, low pollution and green technology.

ZOZEN’s YLW series thermal oil heater is developed based on chain grate. It can provide high-temperature heat source at various temperatures below 350℃, suitable for various production processes such as dyeing, drying, slashing and printing which require high-temperature and low-pressure heating supply. The YLW series boiler also can realize the precise temperature control via advanced oil temperature and pressure control system to greatly improve the heat energy utilization rate. Recently, Kay & Emms has decided to upgrade the production equipment and signed a cooperative agreement with ZOZEN on the YLW series coal-fired thermal oil heater project.

high safety and high efficiency hot water boiler, ZOZEN WNS series gas fired boiler not only adopts advanced low NOx burners. And through the flue gas recirculation technology, about 10% -30% of the flue gas at the tail of the boiler is sucked into the air inlet of the burner through the flue gas pipe, mixed with the combustion-supporting air, and then entering the furnace, thereby reducing the temperature and oxygen concentration in the combustion area, and finally reducing The amount of thermal NOx is generated, and the NOx in the tail gas of the boiler are less than 30mg/Nm3, which meets the requirements of low nitrogen emissions of the enterprise.enterprise.

ZOZEN has a number of leading automatic welding, rolling, assembly production lines and hydraulic test workshops in the industry, which fully ensure the quality of the butt joints of the pipes, as well as the inner ring, middle ring and outer ring disks during the production of the heat-conducting oil boiler body. Assembly accuracy between tubes.

Moreover, ZOZEN professionals provide full guidance from the installation and the trial operation of the boiler to the training of the boiler operator, so that each user can enjoy one-stop worry-free service from pre-sales to after-sales, high safety and high efficiency hot water boiler.