oil and gas hot water boiler manufacturer, ZOZEN Boiler performs well in aspects of technology, quality and market reputation

oil and gas hot water boiler manufacturer, The primary purpose of the boiler is to supply energy to the facility's operations – for comfort heating, manufacturing process, laundry, kitchen, etc. The nature of the facility's operation will dictate whether a steam or hot water boiler should be used. Hot water is commonly used in heating applications. Under these conditions, there is a wide range of ZOZEN hot water boiler products available.

During the processing of broilers, whether it is retort sterilization, baking and cooking, or heating and drying, the heat source provided by the steam boiler is required. ZOZEN successfully won the full recognition of the Chia Tai Group with its systematic solutions, and became the  General Contractor of Jilin Zhengda Boiler, providing it with three 1.2 million kcal gas-fired thermal oil heaters, including pipe laying from the boiler room to the production floor.

The SZS series gas-fired steam boiler produced by ZOZEN Boiler adopts the D-type and full membrane wall structure. The large furnace space ensures the sufficient combustion of the fuel and has good gas tightness. Meanwhile, the furnace body is made of high-quality aluminum silicate fiber and refractory mud for insulation to control the furnace body temperature below 45℃ and control the heat loss; with the additional energy-saving device at the end of the flue gas duct, the boiler thermal efficiency can be improved to more than 98%.

oil and gas hot water boiler manufacturer, With thermal efficiency over 82% and NOx emissions less than 100mg/Nm3, ZOZEN DZL series boilers feature high efficiency and low emissions. They adopt single-drum structure and a chain grate. The heat transfer coefficient of threaded smoke tubes is 1.8 times higher than ordinary tubes. In order to expand the capacity, PT. New Hope Indonesia introduced ZOZEN DZL series coal-fired steam boiler to provide efficient and reliable heat source guarantee for feed production. 

ZOZEN boilers adopt the ultra-low nitrogen burner with flue gas recirculation method to realize low NOx emission. Adding flue gas to the combustion air to reduce the oxygen content in the combustion air and lower the flame temperature at the combustion center, so as to greatly reduce the generation of NOx. At the same time, superimposed use of world advanced technologies such as staged combustion of ultra-low nitrogen burner and internal flue gas circulation realizes the stable and low emission of NOx.

The grate bracket of ZOZEN chain grate boilers adopts double-layer bracket. The upper layer uses light rail while the lower layer uses channel steel. The upper layer is heated while the lower layer is stressed. This has changed the traditional grate bracket structure which uses angle steel and friction bars and can avoid deformation. The active grate runs on the light rail. The 72-hour cold test run is carried out on the grate before the grate leaves the factory to ensure the smooth operation of the grate without deviation or jamming, oil and gas hot water boiler manufacturer.

The two sides cooperated well for the steam boiler project in Bangladesh. ZOZEN will continue to provide high quality products for the global industrial boiler market in the future.