three way catalytic converter for direct gas fired boiler, ZOZEN boiler obtains outstanding achievements in the overeas market

As a leading manufacturer of industrial boilers, ZOZEN has a network of sales around the world. Recently, ZOZEN mid-temperature and mid-pressure steam boiler project in Bangladesh was in full swing.

Recently, data from the National Bureau of Statistics showed that China’s industrial boiler output from January to July in 2020 was 184,780.8 tph, a decrease of 24.8% year-on-year, showing a downward trend. Against the background of a sharp decline in the domestic industrial boiler industry, ZOZEN Boiler managed to overcome the difficulties and achieved a slight increase in output.

ZOZEN DHL series coal-fired boiler is field assembled and has an external drum, which has the advantages of compact structure, low steel consumption, and fast heating of the corner tube boiler. It also adopts the front and rear arch covering furnace structure to build the refractory concrete  in the lower section of the front wall of the furnace. The front arch is the fire arch, while the rear arch is the ignition arch, three way catalytic converter for direct gas fired boiler.

three way catalytic converter for direct gas fired boiler, In September, ZOZEN SZL series biomass-fired boiler provided for Inner Mongolia Jinshan Mining had been debugged and put into operation smoothly. The boiler has a higher furnace and reasonable grate rotate speed to ensure the sufficient fuel combustion and improve the thermal efficiency to 88% and above. At the same time, the boiler convention area is also equipped with an ash removal device independently developed by ZOZEN which not only has good tightness, but also greatly reduces the workload of the boiler operation and maintenance personnel, so as to help Jinshan Mining achieve clean production and build a green mine.

ZOZEN WNS series gas fired boiler not only adopts advanced low NOx burners. And through the flue gas recirculation technology, about 10% -30% of the flue gas at the tail of the boiler is sucked into the air inlet of the burner through the flue gas pipe, mixed with the combustion-supporting air, and then entering the furnace, thereby reducing the temperature and oxygen concentration in the combustion area, and finally reducing The amount of thermal NOx is generated, and the NOx in the tail gas of the boiler are less than 30mg/Nm3, which meets the requirements of low nitrogen emissions of the enterprise.enterprise.

The cold working, also known as “iron tailor”, is a kind of comprehensive technology to process metal sheet material, tubular product and proximate matter into various kinds of products without changing the cross section characteristics, which includes straightening, laying off, blanking, cutting, bending, stamping, assembling, riveting, welding, etc. At ZOZEN’s production lines, the number of cold working workers is the largest except that of welding workers.

All boilers are subject to damage if proper water treatment procedures are not followed. This is an important consideration both during operation and when the boiler is idle. To avoid damage and costly repairs, monitor water chemistry routinely and ensure that you are supplying your boiler with soft water at all times.