horizontal multitubular boiler for textile industry, the technicians of ZOZEN boiler deeply explain the principle

As a professional boiler manufacturer, ZOZEN Boiler, with the support of policy, has formed a global sales network to cooperate with many overseas enterprises. Its products are exported to Australia, South Africa, Indonesia, Arabia, Thailand and many other areas.

This time, ZOZEN Boiler participated in the photovoltaic industry chain project with an annual output of 500 MW in Ankara, Turkey, which was a recognition for the brand and strength of ZOZEN Boiler.

ZOZEN molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃, horizontal multitubular boiler for textile industry.

ZOZEN biomass-fired boilers refer to the boilers fueled by biomass energy, which are typically energy-saving and eco-friendly products. Biomass fuel usually refers to the agricultural and forestry wastes such as various crop straws, leaves, wood chips and so on, which are renewable and recyclable. The operating cost of biomass-fired boilers is low, which is only a half of that of gas-fired boilers. However, the initial investment cost of biomass-fired boilers is higher than that of oil-fired or natural gas fired boilers. Biomass-fired boilers are good alternatives to gas-fired boilers when replacing the coal-fired boilers. At present, the technical parameters of biomass-fired boilers are 2-75 tph (rated capacity) and 2.0-116 MW (rated thermal power).

The grate bracket of ZOZEN chain grate boilers adopts double-layer bracket. The upper layer uses light rail while the lower layer uses channel steel. The upper layer is heated while the lower layer is stressed. This has changed the traditional grate bracket structure which uses angle steel and friction bars and can avoid deformation. The active grate runs on the light rail. The 72-hour cold test run is carried out on the grate before the grate leaves the factory to ensure the smooth operation of the grate without deviation or jamming, horizontal multitubular boiler for textile industry.

Nantong Kedi Medical Material Technology Co., Ltd. is engaged in the research, development and production of products such as medical non-woven fabrics, dressings, wound care materials, surgical sanitary products, etc. The products are very popular in the market. In July 2019, Kedi Medical Material decided to expand the production project of processing 8,000 tons of medical non-woven fabrics. As an important piece of equipment of the hot-rolled non-woven fabric production line, the performance of energy saving and high efficiency of gas-fired thermal oil heaters will directly affect the product quality and production efficiency of Kedi Medical Material. With advanced production technologies, scientific testing methods and considerate after-sale service, ZOZEN provided Kedi Medical Material with the YQW series horizontal thermal oil heaters.

In recent years, attention to environmental protection and sustainable development has been raised to a new height. Both Lenzing Group and ZOEN Boiler are constantly practicing the concept of sustainable development. There may still be new challenges in the future, but as a large-scale enterprise with social responsibility, ZOZEN Boiler will continue to insist on technological innovation and work with partners to achieve the unified development of economic, environmental and social benefits.