dealer commercial 2t natural gas boiler brunei, ZOZEN automatic freen factory provides strong support for high-quality boilers

dealer commercial 2t natural gas boiler brunei, The year 2020 is a significant year for ZOZEN Boiler that we together overcame the difficulties brought by COVID-19, implemented the lean factory project, carried out performance appraisal in the whole company, etc. This year, as ZOZEN Boiler is undergoing a huge change from top to bottom, the performance appraisal and promotion system of front-line staff also has important changes.

dealer commercial 2t natural gas boiler brunei, From November 15 to 17, 2020 China Aerated Concrete Industry Conference and the 40th Association Annual Meeting was held in Chongqing. As a boiler equipment supplier with outstanding performance in the aerated concrete industry, Wuxi ZOZEN Boilers Co., Ltd. sent the representative to participate in the event.

The function of CFB boiler secondary air: Ensuring that the combustibles overflowing from the dense phase zone will be further oxygen-enriched in the lean phase zone (suspension section), so that the fuel is fully burned in the furnace and the temperature difference between the upper and lower furnace reduces.

dealer commercial 2t natural gas boiler brunei, ZOZEN biomass-fired boilers refer to the boilers fueled by biomass energy, which are typically energy-saving and eco-friendly products. Biomass fuel usually refers to the agricultural and forestry wastes such as various crop straws, leaves, wood chips and so on, which are renewable and recyclable. The operating cost of biomass-fired boilers is low, which is only a half of that of gas-fired boilers. However, the initial investment cost of biomass-fired boilers is higher than that of oil-fired or natural gas fired boilers. Biomass-fired boilers are good alternatives to gas-fired boilers when replacing the coal-fired boilers. At present, the technical parameters of biomass-fired boilers are 2-75 tph (rated capacity) and 2.0-116 MW (rated thermal power).

In terms of welding technology, ZOZEN longitudinal and circumferential seam welding adopts advanced automatic submerged arc welding technology, and 100% X-ray detection is carried out on the welding seam to ensure the welding quality. The welding of the smoke tube and tube sheet adopts pre-expansion first to eliminate the gap between the tube and tube sheet, and then adopts the automatic argon arc welding technology, which can effectively eliminate the stress and extend the service life of the boiler.

Meanwhile, a set of 36 tph ZOZEN DZL series biomass-fired boiler was in installation in Shandong Province. This boiler system would provide the stable heat source support for the production base of Heze Huihao Textile Co., Ltd. with an annual output of 3,000 tons of knitted fabric and 3,000 tons of rinsed knitted fabric. ZOZEN biomass-fired boiler had a reasonable primary and secondary air ratio and the SNCR intelligent denitrification device at the boiler end, which could ensure that the NOx emission concentration was less than 50mg/Nm3 to meet the environmental protection standards in Shandong Province, helping Huihao Textile realize the ultra-low NOx emission.

With the rapid development of the aerated concrete industry, ZOZEN air preheating type gas-fired boiler has also been widely used to provide solid support for the industry development. It has always been the development goal of ZOZEN Boiler to produce boiler products that are highly compatible with various industries. In the future, ZOZEN Boiler will continue to move towards this goal and bring users more satisfactory boiler solutions.