Purchasing a new boiler is a big decision for any company or organization. It means investing thousands of dollars in a piece of equipment you’ll be using for many years to come. Needless to say, it’s not a venture you should take lightly. You need to know ahead of time exactly what you should be looking for in a new boiler.
Any unusual noises should always be treated seriously.
One of the first things to check if a boiler is unusually noisy is the boiler's thermostat. If the thermostat is malfunctioning, water can become too hot and begin to boil, which could cause loud noises. If the thermostat is broken it may need to be replaced to prevent the water from heating up so much.
Another reason for a noisy boiler could be mineral deposits. As the water heats up inside the boiler, minerals may sink to the bottom of the tank and affect the heat exchange. This may create hot spots within the boiler in which water is overheated, leading to loud noises.
Low water pressure is also a concern that can result in loud noises. If water pressure is low, the boiler is tend to be overheat.
Safety is always a top priority when working with industrial boilers, at least it should be. Fortunately, safety has become less of an issue with more modern water tube boilers. Compared to traditional fire tube boilers, water tube boilers are far safer, almost to the point where you don’t have to worry about a catastrophic explosion taking place.
The choice between a steam system or a thermal fluid system is governed by the process requirements. The range or process temperature is a deciding factor. If the system’s required temperature is above the freezing point of water (0°C) and below approximately 160°C, the choice is usually steam. However, if the required temperature is above 160°C, thermal fluid may be a better solution. Thermal oil heater systems can be designed with maximum operating temperatures to 325°C.
Yes, it is recommended to turn your boiler off whilst the tank is being filled and to leave it off for a short period afterwards of up to 30 minutes. This will ensure that any sediment that has settled on the base of your tank is not stirred up and drawn into your fuel line.
A fire tube steam boiler is a boiler where the combustion gases from the burner are channeled through tubes that are surrounded by the fluid to be heated. The boiler body is the pressure vessel and contains the fluid. In most cases, this fluid is water that will circulate for heating purposes or become steam for use in processing.
Each set of tubes through which the combustion gas passes, before making a turn, is considered a "step". Consequently, a three-step boiler will have three sets of pipes with the outlet located at the rear of the boiler.
The primary objective of an industrial boiler is the generation of steam. Steam is generated by heat transfer at a constant pressure. The fluid, which is initially in a liquid state, is heated, produces a variation in its phase and becomes saturated vapour.
This saturated steam can then be used for different applications such as sterilization, fluid heating or electricity generation.
