The slag produced by a biomass-fired boiler can be reused to avoid energy waste and environmental pollution. There are many ways to reuse the slag. For example, the slag can be used to improve soil and improve soil performance. If it contains potassium carbonate and organic matter, it can also be used to produce compound fertilizers. In addition, the slag is a kind of plant ash, it is also a good thermal insulation material for steelmaking.
After combustion, biomass-fired boiler fuel will generate energy and also produce some combustible matter in fly ash which will have bad influence on the surrounding environment. Therefore, in order to realize the goal of environmental protection, we should reduce the generation of combustible matter in fly ash in biomass-fired boiler fuel.
Because coal fuel is expensive and coal combustion can cause serious environmental pollution, it is necessary to transform the coal-fired boiler into gas-fired boiler. However, the reconstruction of coal-fired boiler is not a small project. Only pay close attention to every phase of the reconstruction process can avoid failure.
If the pumps of a coal-fired boiler are not absorbing water, it could be due to several reasons. It's essential to diagnose the issue accurately for an effective solution. Here are some common causes:
Air Locks in the Pump or Suction Line: If there is trapped air within the pump or the suction line, it can prevent the pump from creating the necessary vacuum to draw water.
Low Water Level in the Feed Tank: If the water level in the feed tank is too low, the pump may not have enough water to dra...
Increased Efficiency: Economizers and condensers are designed to capture and utilize the waste heat from boiler flue gases. This process significantly improves the overall efficiency of the heating system.
Reduced Fuel Consumption: By maximizing heat recovery, these devices lower the amount of fuel needed to reach the desired temperature, leading to substantial fuel savings and reduced operating costs.
Lower Emissions: Improved efficiency translates to less fuel burned, which directly reduces ...
If the burner motor of a gas-fired boiler is running and voltage is present at the controller terminal, but there is no ignition followed by a system failure and stop, this situation can be attributed to several potential issues. Here's a breakdown of what might be happening and what to check:
Ignition System Failure: The ignition system, which may include spark electrodes or an igniter, could be faulty. Check for any signs of damage, misalignment, or dirt on the igniter or electrodes.
Control...
Using artificially softened water in the heating circuit with your boiler can potentially cause issues and is not recommended.
Artificially softened water contains high levels of sodium ions, which can cause corrosion of the boiler and other components in the heating system. This corrosion can damage the boiler and other components, leading to leaks and reduced efficiency.
In addition, artificially softened water can cause problems with water pressure and flow rate, which can i...
Drying the moisture in the fuel of a biomass-fired boiler is important to ensure efficient combustion and prevent issues such as fuel bridging, clumping, and poor boiler performance. Here are some methods that can be used to dry the moisture in biomass fuel:
1. Sun drying: This method involves spreading the biomass fuel, such as wood chips or sawdust, in a thin layer in a sunny, well-ventilated area. The sun's heat and wind will help to evaporate the moisture in the fuel.
2. Fo...
