Boiler is a kind of thermal energy conversion equipment composed of drum and furnace. It uses fuel combustion to heat water into steam or hot water to provide power for production or help auxiliary production. With the continuous improvement of industrial manufacturing technology, boiler's control has also changed from the traditional full manual operation to the present automatic intelligent control.
A well designed and operated biomass boiler burning fuel within the specification of the boiler should not produce any smoke, but black smoke may be produced if the fuel is too wet for the boiler. All biomass boilers produce some oxides of nitrogen (NOx), particularly nitrogen dioxide (NO2). While NOx emissions from gas boilers have been reduced significantly in recent years through the use of low NOx burners which burn at a temperature slightly below that at which NOx forms, the nature of biomass combustion, and the need to ensure the complete combustion of wood gases, means that combustion takes place at a temperature where atmospheric oxygen and nitrogen can chemically combine. The better the quality of the combustion control system on a biomass boiler, the lower the NOx emissions will be. In general, biomass boilers produce less NOx than oil boilers. Biomass boilers do not produce any oxides of sulphur (SOx).
Heating surface is one criterion used when comparing boilers. Boilers with higher heating surface per boiler horsepower tend to be more efficient. Traditional packaged boilers are offered with 5 square feet of heating surface per boiler horsepower as an optimum design for peak efficiency, but new design breakthroughs allow ZOZEN boilers to have increased efficiency using more effective heating surface and reducing the size of the footprint.
A hybrid or combination boiler system refers to a heating system that combines two different types of heating technologies or fuels to optimize efficiency, performance, and cost-effectiveness. This system typically involves the integration of a traditional gas or oil boiler with a renewable energy source, such as a solar thermal system, a biomass boiler, or a heat pump. The idea is to harness the strengths of both systems to achieve greater energy efficiency and environmental sustainability.
Ke...
If the burner motor of a gas-fired boiler is running and voltage is present at the controller terminal, but there is no ignition followed by a system failure and stop, this situation can be attributed to several potential issues. Here's a breakdown of what might be happening and what to check:
Ignition System Failure: The ignition system, which may include spark electrodes or an igniter, could be faulty. Check for any signs of damage, misalignment, or dirt on the igniter or electrodes.
Control...
Choosing a thermal fluid (also known as a heat transfer fluid or HTF) for an industrial boiler application is a critical decision, as it directly impacts the safety, efficiency, and performance of your heating system. Here’s a step-by-step guide to help an industrial boiler buyer or manufacturer choose the right thermal fluid:
1. Operating Temperature Range:Determine the required operating temperature range of your application. Choose a thermal fluid that has a bulk temperature operating ...
A biomass-fired boiler furnace that has multiple issues such as wall cracks, deformation, coking, and tilt, loose bricks, tube wall blockage, burned-out rock wool sealing, and combustion chamber wall damage requires immediate attention to prevent further damage and potential safety hazards.
Firstly, it is recommended to shut down the boiler immediately to prevent any further damage and ensure the safety of the surrounding area. The boiler should not be restarted until all necessary repa...
Strictly control the operating pressure of the environmental thermal oil heater, and do not exceed the specified range. Once there is a trend of exceeding the specified upper limit, immediate measures should be taken.
