The principle of primary and secondary air regulation in circulating fluidized bed (CFB) boilers is designed to maintain stable operating conditions of the boiler, adjusting the volume and temperature of primary and secondary air to achieve efficient combustion and reduce pollutant emissions. Specific adjustment strategies should be optimized and adjusted based on the boiler design and actual operating conditions.
Circulating Fluidized bed steam boiler from ZOZEN
Principles of Primary and Se...
In the whole drying process, we should pay attention to gradually increasing the temperature instead of burning by raging fire; regularly checking boiler's water level and keeping it within the normal range; keeping the flame balanced in the furnace. In addition, we also should properly open the drainage valve and maintain the water level, regularly record the flue gas temperature to control the rise of temperature and high temperature and keep the temperature within the normal range. In general, under these conditions, boiler’s drying quality can be ensured.
The air oxygen content's effect on the boiler is mainly reflected by the effect on the blowing rate. Boiler will have typical phenomena if the blowing rate is high or low.
The coal-fired boiler has always been one of the important boiler types in the industrial production and its operating costs and capacity play an important role in the enterprise operation.
Because coal fuel is expensive and coal combustion can cause serious environmental pollution, it is necessary to transform the coal-fired boiler into gas-fired boiler. However, the reconstruction of coal-fired boiler is not a small project. Only pay close attention to every phase of the reconstruction process can avoid failure.
(1)Ensure normal and stable steam pressure, steam temperature and evaporation.
(2)Avoid coking and burner damage; Ensure the safety of the operation of the superheater; Reduce pollution of combustion.
(3)Make the operation achieve the highest economy.
If the pumps of a coal-fired boiler are not absorbing water, it could be due to several reasons. It's essential to diagnose the issue accurately for an effective solution. Here are some common causes:
Air Locks in the Pump or Suction Line: If there is trapped air within the pump or the suction line, it can prevent the pump from creating the necessary vacuum to draw water.
Low Water Level in the Feed Tank: If the water level in the feed tank is too low, the pump may not have enough water to dra...
Serious coal leakages in the fire grate of coal-fired boilers can be caused by several factors, each impacting the efficiency and safety of the boiler operation. Understanding and addressing these issues is crucial for maintaining optimal performance. Here are some common causes:
Wear and Tear: Over time, the fire grate components can wear down due to the constant exposure to high temperatures and the abrasive nature of coal. This wear can create gaps through which coal can fall.
Improper Grat...
