The most obvious use of boilers in any building, including hospitals, is typically heating for the facility. A reliable steam boiler is one of the most economical ways to provide heat across a large space, especially one with multiple floors.
On a steam raising boiler there are three clear applications for level monitoring devices:
1) Level control - To ensure that the right amount of water is added to the boiler at the right time.
If the impurities in the boiler feedwater are not dealt with properly, carryover of boiler water into the steam system can occur.
Carryover can be caused by two factors:
Three-pass steam boilers are so-called because the combustion gases that are produced inside them in the burner go round a circuit that has three parts before leaving it:
When they reach a certain size, industrial steam boilers are installed in a boiler room which is necessary to ensure safety while they are operating as pressure equipment, in accordance with local regulations.
When determining how much space should be between steam boilers, serviceability should be at the top of your mind. Sure, you want to save space, but you also want to make sure you have plenty of elbow room to service your boiler properly.
One of the most crucial factors that will determine how you space your boiler units is whether your boiler system is being installed in a new construction facility or an existing building that is being retrofitted.
While a new construction giv...
Nox is the generic term for a group of highly reactive gases, all of which contain nitrogen and oxygen in varying amounts. Many of the nitrogen oxides are colorless and odorless. However, one common pollutant, nitrogen dioxide (NO2) along with particles in the air can often be seen as a reddish-brown layer over many urban areas.
Nox forms when fuel is burned at high temperatures, as in a combustion process. The primary sources of Nox are motor vehicles, electric utilities, and other industrial,...
As their name implies, hot water boilers operate by being completely filled with hot water. On the other hand, steam boilers are usually only filled approximately 3/4th of the way full, while the top quarter is reserved for steam.
