According to the Wikipedia, Second-generation biofuels, also known as advanced biofuels, are fuels that can be manufactured from various types of non-food biomass. Biomass here means plant materials and animal waste used especially as a source of fuel.
Advanced biofuels are renewable fuels derived from renewable biomass that achieve a fifty percent greenhouse gas emissions reduction over conventional biofuels. The definition of advanced biofuels includes cellulosic biofuels, biomass-bas...
At present, the research and development technology of gas boilers is very mature. The boiler has obvious advantages of stable operation and less pollutant discharge and energy saving. However, if the boiler is not used for a long time, it is necessary to maintain the boiler to maintain the normal operation at the subsequent startup.
For a boiler to operate stably and efficiently, all links must be properly coordinated without making mistakes. For gas-fired boilers, it is necessary not only to have softened water treatment facilities, but also to carry out regular sewage discharge, which cannot be ignored.
For an industrial boiler with reasonable structural design, its thermal efficiency is relatively high, and its exhaust gas discharge temperature is relatively low, so we must carefully consider the boiler property report form when purchasing the boiler.
According to the differences in fuel and structure, industrial thermal oil heaters are mainly divided into the oil/gas-fired thermal oil heater and coal/biomass-fired thermal oil heater. The basic configurations of the thermal oil boiler system generally are as follows.
The flue gas first enters the cyclone dust collector which acts as a primary dust collector to make the large dust particles in the flue gas settle down. The cyclone dust collector is a dust removal device which uses the centrifugal force generated by the cyclone flow to separate the dust particles from the air flow. Afterwards, the flue gas enters the wet scrubber dust collector which is a circular-type cylinder. The circulating water enters the dust collector from the upper overflow tank to form a uniform water film on the inner wall of the dust collector. The flue gas is induced tangentially or spirally from the lower part of the cylinder and rotates in the cylinder. Under the influence of the centrifugal force, the dust particles are separated from the flue gas and then the flue gas is also spirally led out from the top of the cylinder. The dust particles are thrown to the water film, transferred to the bottom and finally discharged from the dust port.
Due to the development of boiler technology and relevant policies, gas-fired boilers using eco-friendly fuels are often applied for heating. For thermal power companies, cost is the most important issue.
Gas-fired hot water boilers require high-quality water to improve the boiler performance and extend the service life. If the boiler uses the tap water of water which contains a lot of impurities, magnesium and calcium ions in the water will form white precipitates when the water is heated at high temperatures, which can cause the scaling problem to reduce the heat transfer efficiency of the boiler and bring hidden dangers of the boiler safety.
