According to the Wikipedia, Second-generation biofuels, also known as advanced biofuels, are fuels that can be manufactured from various types of non-food biomass. Biomass here means plant materials and animal waste used especially as a source of fuel.
Advanced biofuels are renewable fuels derived from renewable biomass that achieve a fifty percent greenhouse gas emissions reduction over conventional biofuels. The definition of advanced biofuels includes cellulosic biofuels, biomass-bas...
A condensing boiler can condense the water vapour in the flue gases and withstand the corrosive and acidic qualities of the flue gas condensate. Although most boilers can condense the flue gasses, only boilers that have heat exchangers constructed from materials able to withstand the corrosion should be used in condensing application. Condensing boilers with primary and secondary heat exchanger do not work well as they are not able to fully condense and defeat the purpose of using a condensing boiler. Also, boilers with this arrangement are prone to condensation in the primary heat exchanger at lower firing rate which can cause damage to the heat exchanger.
One of the biggest issues related to natural gas explosions is that in the industrial world, people just don’t understand that natural gas piping repairs are different from other piping repairs.
Three-pass steam boilers are so-called because the combustion gases that are produced inside them in the burner go round a circuit that has three parts before leaving it:
Whether it's an industrial hot water boiler or an industrial steam boiler, they all depend on fuel to run. The process of heating is initiated as the burner heats or eventually evaporates the water inside of it. It's actually transported via intricate pipe systems.
Steam boilers transport through the pressure created by the process, while hot water boilers use pumps to move heat throughout the system. Eventually the condensed steam or cooled water returns back through the pipes to the boiler system, so the heating process can be initiated again.
As the boiler creates heat energy, a byproduct of the process — flue gases — are exited through a chimney system. Because of this, regulating the industrial boiler emissions is a very serious issue.
Oil Fired Boilers generally require Day Oil Tank to store oil and this oil is transported to a burner through oil piping and oil pump. On the other hand, High-Efficiency Gas Fired Boilers are exactly same as Oil Fired Boilers in construction and the only difference is the transportation of gas to burner requires gas train which comprises of the gas regulator that regulates pressure, the gas strainer to remover dirt from gas while no such valves are required in oil fired boilers.
The efficiency of a coal-fired boiler depends on the loss of the boiler, the best efficiency in the boiler can be achieved if the losses are kept to the minimum. Since 50% of the losses are dependent on the fuel and ambient condition, the best efficiency can be achieved by properly tuning the other 50%, i.e. mainly carbon loss and dry gas loss.
For an industrial boiler with reasonable structural design, its thermal efficiency is relatively high, and its exhaust gas discharge temperature is relatively low, so we must carefully consider the boiler property report form when purchasing the boiler.
