Due to the development of boiler technology and relevant policies, gas-fired boilers using eco-friendly fuels are often applied for heating. For thermal power companies, cost is the most important issue.
The thermal oil heater, also called the organic heat carrier boiler, is a kind of once-through boiler developed based on the forced circulation design concept. With gas, oil or coal as the fuel and heat conducting oil as the medium, the thermal oil heater adopts the thermal oil pump to force the medium conducting the circulation in the liquid phase. The medium transfers the heat energy to the heating equipment and then returns to the furnace for being reheated. The thermal oil heater has the advantages of high-temperature and low-pressure heating and precise control of the medium.
The biomass-fired steam boiler is used widely and the biomass belongs to the renewable energy with high thermal efficiency which can be applied by many production enterprises.
The thermal oil heater, also called organic heat carrier boiler, provides heat energy for production by heating the heat medium oil. It can realize the high-temperature and low-pressure heating without constant water supply. What are the characteristics of the thermal oil heater?
The thermal oil heater is a heater that uses heat medium oil as medium for heat transfer. The low-pressure and high-temperature heating can be realized by the utilization of the high-temperature characteristics of heat medium oil.If there is too much moisture in the low-temperature heat medium oil, there will be pressure fluctuations, which will cause some other problems. In addition, if the heat medium oil does not flow in the furnace owing to the stop of pump, the oil temperature will rise and exceed the limit value, which not will greatly affect the service life of the heater and cause the deterioration of the heat medium oil.
1. The storage tank is used to store the heat medium oil of the heating system;
2. The storage tank is used to receive the overrunning heat medium oil;
3. The storage tank is used to supplement heat medium oil for the heating system;
4. The storage tank should be placed at the lowest position of the system;
5. A firewall should be placed between the storage tank and the thermal oil heater;
6. The storage tank should be operated at a low liquid level.
1. If there is air in the pump or suction pipe, the air should be discharged.
2. If the depth of the bottom valve immersed in the water is not deep enough, the depth should be increased.
3. If the rotational speed is too slow or the conveyor belt is too loose, the rotational speed should be adjusted and the conveyor belt should be tightened.
4. If the impeller, suction pipe and bottom valve are blocked by dirt, you should check the pump body and clean the dirt.
5. If the height of water conveyance exceeds the regulations too much, the pump head should be adjusted to the specified range.
Loads vary, and a power plant must be capable of handling the minimum load, the maximum load, and any load variations. Boiler selection is often dictated by the variation in load demand, rather than by the total quantity of steam or hot water required. There are three basic types of load variations: seasonal, daily, and instantaneous.