A boiler economizer (also known as an economizer) are mechanical devices intended to reduce energy consumption or perform a useful function such as preheating a fluid. A boiler economizer is essentially a heat exchanger that makes a system more energy efficient by taking enthalpy in fluid streams that are hot, but not hot enough to be used in a boiler – hence recovering more useful enthalpy and improving the steam boiler’s efficiency.
The term Thermal Fluid does not refer to a specific fluid, there are many. There are also many companies that produce a variety of Thermal Fluids.
The most common Thermal Fluids are either Mineral Oil based or Synthetic Oils. The various manufacturers typically produce a series of fluids that each has a recommended operating temperature range. Close consideration should be given to this operating range in selecting a fluid.
There are other considerations as well, consult with f...
One of the biggest issues related to natural gas explosions is that in the industrial world, people just don’t understand that natural gas piping repairs are different from other piping repairs.
On a steam raising boiler there are three clear applications for level monitoring devices:
1) Level control - To ensure that the right amount of water is added to the boiler at the right time.
In addition to water, other fluids can transport heat in industrial boilers, and thermal fluids usually replace water when higher temperatures are needed.
A steam boiler is a water containing vessel which transfers heat generated by a fuel source into steam, which is then piped and directed to points where it could be used while running industrial equipment. The basic idea here is to convert water to steam using a source of heat.
The hot medium oil of the thermal oil heater should be tested regularly to measure and analyze the physical and chemical indicators such as the residual carbon, acid value, viscosity, flash point, melting point and so on, so as to know the quality changes in time and analyze the reasons for the changes. When the acid value exceeds 0.5mgKOH/g, the viscosity change reaches 15%, the flash point change reaches 20%, and the residual carbon (mass fraction) reaches 1.5%, it indicates that the performance of the hot medium oil has changed. Therefore, the user needs to regularly add the new heat carrier when using the hot medium oil to keep the residual carbon in the system stable.
