straw fired boilers, if you have any doubt, please find the professional boiler manufacturer Wuxi ZOZEN

With air emission regulations constantly changing, ZOZEN Boiler has adopted new ways to keep up with more stringent standards. ZOZEN eco-friendly boilers were launched to the market, which come in various sizes. These eco-friendly boilers are more superior and efficient unlike traditional boilers as they smartly recycle heat that would be wasted.

straw fired boilers, With years of efforts, ZOZEN has obtained outstanding achievements in the overseas market. Recently, ZOZEN participated in a large photovoltaic industrial chain project in Turkey, which showed that the brand and strength of ZOZEN were recognized by the overseas market.With an annual output of 500MW, the photovoltaic industrial chain project in Turkey is a key project of the Belt and Road China-Turkey cooperation project. On December 12, the opening ceremony of the project was held at the Başkent OIZ Industrial Park in Ankara.

straw fired boilers, The DZL series biomass-fired horizontal three-pass water-fire tube chain grate boiler is pre-assembled boiler with a capacity of 2-20 tph (hot water boiler: 1.4-14MW) and a thermal efficiency of over 88%. By extending the furnace arch, increasing the furnace height and adjusting the width and length of grate, ZOZEN takes the lead in solving the problems that easily occur in biomass-fired boilers such as furnace arch collapse, furnace door burnout, hopper tempering and tube wall coking. It has the characteristics of wide fuel adaptability, small covering area, convenient installation and high thermal efficiency.

ZOZEN’s oil-fired/gas-fired skid-mounted steam boiler has obvious advantages of integrated skid-mounted delivery, compact structure and cost saving, which immediately attracted the attention and favor of the Myanmar Factory of Xindaxin Food after it came onto the market. ZOZEN had completed the customization of full set of skid-mounted boiler system to meet the actual requirements of the factory. After it is delivered to the boiler room of the Myanmar factory, it can run automatically with water, electricity and oil supply when the start button is pressed.

Designed to wrap the whole furnace body for heat preservation. There are no heat transfer supports between the furnace body and the outside surface. The appearance is mirror polished stainless steel with a protective coating. After the boiler is installed, remove the coating and show the mirror polished stainless steel appearance. Advantages: a good-looking appearance, low temperature of surface, low heat dissipation.

The waveform stove furnace is an important part of the WNS series of oil-fired/gas-fired boiler. This part is directly exposed to the radiation of high-temperature flame and erosion of high-temperature flue gas. The use of the axial expansion and contraction of waveform stove furnace can reduce the thermal stress generated by the shell, tube plate and furnace itself, and more importantly, reduce the stress concentration caused by the elongation of furnace at the connection between furnace and tube plate. At the same time, the waveform stove furnace strengthens the flue gas disturbance, effectively improves the heat transfer effect of unit area and volume, and further improves the thermal efficiency of boiler.

All boilers are subject to damage if proper water treatment procedures are not followed. This is an important consideration both during operation and when the boiler is idle. To avoid damage and costly repairs, monitor water chemistry routinely and ensure that you are supplying your boiler with soft water at all times, straw fired boilers.