1ton diesel fired steam boiler, ZOZEN obtains the DOSH certification and enters the industrial boiler market in Malaysia

The new era creates new demands. As the economic growth gradually changes from extensive type to intensive and eco-friendly type, all industries are facing unlimited opportunities and challenges. ZOZEN Boiler, as a typical representative of industrial boiler manufacturers, has promoted the transformation and upgrading of various industries with the eco-friendly gas-fired boilers, which not only helps the cooperative partners of ZOZEN Boiler achieve the green development, but also proves the value of itself.

Recently, three sets of customized ZOZEN gas-fired boilers have been delivered after passing the quality tests. The boilers will enter the installation phase in late March when arriving at the UYUNI port.This project is located at the Uyuni Salt Flat, the largest salt flat in the world with the largest lithium reserves. Once the installation is completed, the boiler project will provide a reliable heat source for the new plant of YLB and assist the development and commercialization of salt-flat resources, 1ton diesel fired steam boiler.

1ton diesel fired steam boiler, The SZS series gas-fired steam boiler produced by ZOZEN Boiler adopts the D-type and full membrane wall structure. The large furnace space ensures the sufficient combustion of the fuel and has good gas tightness. Meanwhile, the furnace body is made of high-quality aluminum silicate fiber and refractory mud for insulation to control the furnace body temperature below 45℃ and control the heat loss; with the additional energy-saving device at the end of the flue gas duct, the boiler thermal efficiency can be improved to more than 98%.

As a hot-selling boiler type of ZOZEN Boiler, WNS series gas-fired boiler has become the heat source equipment of many Yili Dairy production lines in various areas with the advantages of high thermal efficiency and low NOx emissions to provide the stable high-temperature steam for the sterilization and fermentation of dairy products.

The boiler hydrostatic test is a test of strength and tightness with pressurized water after the boiler or components are assembled. The main purpose of the hydrostatic test is to test the tightness and compression strength of boiler pressure-bearing components, tell whether there is leakage of welding seams, flange joints and pipe expansions, and watch the deformation conditions of pressure-bearing components with naked eyes. Practice has proved that the boiler defects can be found through the hydrostatic test, and the safety of boiler operation can be ensured after the corresponding measures are taken in time. Therefore, the hydrostatic test is an important step and means to ensure the safe boiler operation.

In September, ZOZEN SZL series biomass-fired boiler provided for Inner Mongolia Jinshan Mining had been debugged and put into operation smoothly. The boiler has a higher furnace and reasonable grate rotate speed to ensure the sufficient fuel combustion and improve the thermal efficiency to 88% and above. At the same time, the boiler convention area is also equipped with an ash removal device independently developed by ZOZEN which not only has good tightness, but also greatly reduces the workload of the boiler operation and maintenance personnel, so as to help Jinshan Mining achieve clean production and build a green mine.

ZOZEN Boiler has always invested a lot in the research and development of the environmentally friendly industrial boilers with the long-term strategy and firm determination to bravely move forward on the road of green and sustainable development, 1ton diesel fired steam boiler.