Thermal fluid degradation or “burn-up” in a thermal fluid heater can be a significant issue that leads to the loss of fluid properties, system inefficiency, and potential equipment damage. Here are the common reasons why thermal heating fluid may degrade or burn up in your thermal fluid heater:
1. Overheating:
Exceeding the thermal fluid’s maximum recommended operating temperature can lead to ‘cracking’ or breaking down of the fluid. This may produce low molecular...
The water level of steam drum can reflect the condition between feedwater quantity and evaporation quantity of boiler. If the two parameters maintain a stable balance, the water level also remains unchanged; otherwise, the water level will rise or fall. Besides, there is also a false water level phenomenon. How do we understand the false water level?
Most petroleum products can be used as fuel, and boiler oil is a kind of refined oil, which is widely used in power plants and industrial boilers. Boiler oil is mainly made of petroleum cracking residue oil and straight-run residue oil, which is characterized by high viscosity and high content of non-hydrocarbon compounds, gum and asphaltene.
The formula of boiler oil mainly includes the following indicators: viscosity of the boiler oil, sulphur content, density, flash point, water content and ...
Gas-fired boiler is a kind of thermal equipment that uses the thermal energy released by fuel combustion or other thermal energy to heat the medium to the rated temperature. With the strict environmental protection, gas-fired boilers are widely used in power generation, heating, factory processing and so on. Boiler thermal power refers to the continuous heat production per unit time of hot water boiler at rated parameters, rated flow, designed fuel and guaranteed efficiency. So how to convert th...
The boiler needs to blow off every day, and it is advisable to reduce the blowdown to below the boiler water level every time.
The boiler water level meter can record the boiler water level in detail, and the water level has a great influence on the boiler, so we should ensure that the boiler water level is within the normal range.
When the gas-fired boiler is running, there will be pressure inside, which can provide sufficient power for all kinds of production equipment. However, if the press...
1. Water leakage on the inner wall: Water leakage on the inner wall can be divided into three types: boiler leakage, water wall leakage and downcomer leakage. If the leakage holes of boiler barrel and water wall are relatively small, it is ok to use steel with the same steel grade for patching and flaw detection. If the downcomer is leaking, it needs to be replaced.
2. The hand hole leaks: you can re-install it from another angle to see if the hand hole cover is deformed. If it is deformed, you...
Water and electricity are not available;
Circulating water pump is not running;
Water flow switch is different;
The 200V 380V power supply is not connected;
The valve is not opened;
The controller switch is set incorrectly;
There is a problem with the controller circuit;
There is something wrong with the programmer;
Leak detection has not been checked;
Air pressure switch impassability;
Air pressure switch 1-3 impassability;
Overtemperature protection and combustion heat protection;...
The first technical problem is the reconstruction of boiler body:
The coal-fired boiler is mainly grate firing boiler. For small water-tube hot-water boilers, it may lead to the water temperature at the outlet of the riser exceeding the limit or overheating boiling or even vaporization. For shell-and-tube boilers, the rising flue gas temperature at the furnace outlet will make the working conditions of the tube plate worse, thus causing cracks and leakage of the tube plate.
