The flue gas first enters the cyclone dust collector which acts as a primary dust collector to make the large dust particles in the flue gas settle down. The cyclone dust collector is a dust removal device which uses the centrifugal force generated by the cyclone flow to separate the dust particles from the air flow. Afterwards, the flue gas enters the wet scrubber dust collector which is a circular-type cylinder. The circulating water enters the dust collector from the upper overflow tank to form a uniform water film on the inner wall of the dust collector. The flue gas is induced tangentially or spirally from the lower part of the cylinder and rotates in the cylinder. Under the influence of the centrifugal force, the dust particles are separated from the flue gas and then the flue gas is also spirally led out from the top of the cylinder. The dust particles are thrown to the water film, transferred to the bottom and finally discharged from the dust port.
It is inevitable for gas-fired boilers to produce noise including heat exchange noise, aerodynamic noise, mechanical running noise and other noise after ignition.
Facing the aggravation of environmental pollution, many industries have been required to meet the pollutant emission standards. As a kind of thermal energy equipment, the boiler has high pollutant emission. However, the implementation of environmental protection policies has prompted enterprises to use energy-saving and eco-friendly boilers. Therefore, let us talk about the characteristics of the gas-fired condensing boiler here.
The gas-fired steam boiler is used widely and meets the current environmental protection standards. What are the parameters of a set of 2 tph gas-fired steam boiler and what are the gas fuels?
In the boiler operation,the flue gas discharged from the flue gas duct has a certain temperature. However, the abnormal increase of flue gas temperature in boiler's flue gas duct is usually accompanied with other abnormal phenomena. In this regard, corresponding measures should be taken for adjustment based on the reason analysis.
The exhaust gas heat loss of coal-fired boiler is caused by the flue gas removed by final stage heat exchanger. The flue gas will take away a part of heat, mainly including the heat taken away by dry flue gas and the sensible heat with water vapor in the flue gas. What’s more, if the combustible gas in the coal-fired boiler is not completely burned, there will be heat loss as well. Therefore, this kind of heat loss mainly depends on the content of incomplete combustion products in the exhaust smoke.
In general, gas-fired boiler uses natural gas to heat water in order to provide heat source for underfloor heating and heating radiator, while condensing gas-fired uses condensation technology to recycle the thermal energy from the exhaust gas.
