According to the differences in fuel and structure, industrial thermal oil heaters are mainly divided into the oil/gas-fired thermal oil heater and coal/biomass-fired thermal oil heater. The basic configurations of the thermal oil boiler system generally are as follows.
Question details (Performance):1. High temperature of motor, fast temperature rise.2. Overload, high outlet pressure and frequent safety valve open often.3. The vibration is intensified, the side vibration of the fan motor coupling is large, and the fan body never vibrates to vibration.4. No obvious vibration was found in no-load test of fan motor. Answer: Fault reason:Fan bearing vibration is common fault in the operation, the vibration of the fan will cause damage of bearing and blade, bolt looseness, chassis and wind damage, fan vibration rises abruptly in the operation. this is because when the gas enter impeller and the rotating blade working face has certain angle, according to the principle of fluid mechanics, gas from non-working face must be a spiral blade, so the dust particles in the gas will slowly sedimentation due to vortex. Airfoil blades are very easy to accumulate dust. When the accumulated ash reaches a certain weight, a part of the large amount of accumulated ash wi
The pollution discharge of the biomass-fired boiler is less than the coal-fired boiler. It is also necessary to deal with the exhaust gas of the biomass-fired boiler to meet the national standards before boiler ignition and operation.
Because coal fuel is expensive and coal combustion can cause serious environmental pollution, it is necessary to transform the coal-fired boiler into gas-fired boiler. However, the reconstruction of coal-fired boiler is not a small project. Only pay close attention to every phase of the reconstruction process can avoid failure.
Increased Efficiency: Economizers and condensers are designed to capture and utilize the waste heat from boiler flue gases. This process significantly improves the overall efficiency of the heating system.
Reduced Fuel Consumption: By maximizing heat recovery, these devices lower the amount of fuel needed to reach the desired temperature, leading to substantial fuel savings and reduced operating costs.
Lower Emissions: Improved efficiency translates to less fuel burned, which directly reduces ...
Ash accumulation on the heating surface.
The scaling and ash deposition on the water-cooled wall of the furnace and the ash deposition of the superheater, convention tube bundles, economizer and preheater can increase the thermal resistance of the flue gas, weaken the heat transfer, lessen the cooling effect of the flue gas and increase the exhaust gas temperature of the gas-fired boiler.
Too high excess air coefficient.
Under normal circumstances, as the furnace outlet excess...
In addition to quality, price is also an aspect that most corporate users are very concerned about when they purchase the gas-fired thermal oil heater, so what is the price of a set of high-quality gas-fired thermal oil heater?
1. The types and parameters of thermal oil heater, such as rated thermal power, rated working temperature, etc.
Rated thermal power: heat output per unit time. Thermal oil heaters with different heat output per unit time have different prices.
Rated wor...
