When purchasing the gas-fired boiler, the enterprise will generally require to visit the boiler factory at the later period of boiler procurement. Via visiting the boiler factory, the enterprise can have a comprehensive understanding of the operation process, production scale, product quality details, corporate management level, factory shipment and other information of the boiler factory, and can further understand the service quality of the boiler manufacturer.
Most petroleum products can be used as fuel, and boiler oil is a kind of refined oil, which is widely used in power plants and industrial boilers. Boiler oil is mainly made of petroleum cracking residue oil and straight-run residue oil, which is characterized by high viscosity and high content of non-hydrocarbon compounds, gum and asphaltene.
The formula of boiler oil mainly includes the following indicators: viscosity of the boiler oil, sulphur content, density, flash point, water content and ...
As we all know, the transportation cost is generally related to the weight of the boiler, so how much does a 4-ton boiler weigh? How much steel does it contain? According to the fuel, 4-ton boilers are divided into 4-ton gas-fired boilers and 4-ton coal-fired and biomass-fired boilers. The amount of steel used for small-scale coal-fired and biomass-fired boilers is generally 5-7 times of the boiler output (excluding the front and rear arches), and about 25 tons for 4-ton boilers.
The primary air fan of the boiler consists of motor, impeller, casing, air inlet box, current collector, base, regulating control system, etc.
The working process of the primary air fan: Take the medium-speed coal mill and direct-fired pulverizing system as examples, the atmosphere enters the primary air fan and is divided into two paths after being boosted by the primary air fan. One path of the atmosphere enters the primary airpipe in front of the coal mill. The other path enters the air preh...
Modular gas-fired boiler, according to the user's load and design needs, combines several independently operating module units into an integral boiler. By monitoring and calculating the changes of indoor and outdoor temperature and temperature of supply and return water, the computer automatic control system can control each level of modules, automatically adjust the number of modules to start and stop, make the output heat always match the actual required heat load, and ensure that each module ...
1. Water leakage on the inner wall: Water leakage on the inner wall can be divided into three types: boiler leakage, water wall leakage and downcomer leakage. If the leakage holes of boiler barrel and water wall are relatively small, it is ok to use steel with the same steel grade for patching and flaw detection. If the downcomer is leaking, it needs to be replaced.
2. The hand hole leaks: you can re-install it from another angle to see if the hand hole cover is deformed. If it is deformed, you...
1) The insufficient heating surface. In the process of retrofit design or improvement, increase the heating surface.
2) The particle size of the fuel is large, the screening characteristics do not meet the requirements, the material concentration in the suspension section is low, and the heat transfer coefficient is small, which makes the output unable to go up, or shows that the bed temperature is high and coal cannot be added. The solution is to improve the fuel preparation system and control...
Boiler output refers to the maximum continuous output of the boiler under rated parameters (pressure, temperature) and certain efficiency. For steam boilers, it is called rated evaporation, and the unit is tons/hour; For hot water boilers, it is called rated heat production, and the unit is MW.
What are the main factors affecting the output of gas-fired boilers? According to the analysis of ZOZEN Boiler engineers, there are many reasons for the insufficient output of gas-fired boilers,
...
