One of the biggest issues related to natural gas explosions is that in the industrial world, people just don’t understand that natural gas piping repairs are different from other piping repairs.
Three-pass steam boilers are so-called because the combustion gases that are produced inside them in the burner go round a circuit that has three parts before leaving it:
The efficiency of a coal-fired boiler depends on the loss of the boiler, the best efficiency in the boiler can be achieved if the losses are kept to the minimum. Since 50% of the losses are dependent on the fuel and ambient condition, the best efficiency can be achieved by properly tuning the other 50%, i.e. mainly carbon loss and dry gas loss.
As we all know, the stable operation of the natural gas boiler can significantly optimize the operation of the boiler, improve the efficiency of the boiler, and effectively reduce the operating cost of the boiler after effective maintenance. So, what factors will affect the stable operation of natural gas boilers?
The flue gas first enters the cyclone dust collector which acts as a primary dust collector to make the large dust particles in the flue gas settle down. The cyclone dust collector is a dust removal device which uses the centrifugal force generated by the cyclone flow to separate the dust particles from the air flow. Afterwards, the flue gas enters the wet scrubber dust collector which is a circular-type cylinder. The circulating water enters the dust collector from the upper overflow tank to form a uniform water film on the inner wall of the dust collector. The flue gas is induced tangentially or spirally from the lower part of the cylinder and rotates in the cylinder. Under the influence of the centrifugal force, the dust particles are separated from the flue gas and then the flue gas is also spirally led out from the top of the cylinder. The dust particles are thrown to the water film, transferred to the bottom and finally discharged from the dust port.
The high heat transfer of the boiler requires good medium. With the improvement of boiler in the production technology and intelligenlization, gas-fired boilers have more strict requirements for boiler operation medium in order to improve the boiler operating performance, reduce boiler failures and costs.
Thermal oil heaters have the characteristics of low pressure and high temperature. They adopt the special manufacturing technology and are equipped with tailor-made flue gas waste heat recovery systems, so they are energy-efficient with higher thermal efficiency than similar products on the market. They also have a high level of automation.
The gas-fired boiler has the wonderful energy-saving effect and environmental protection performance. The energy-saving effect of the gas-fired boiler is realized by many boiler parts.
