Before coking and boiling, check boiler parts detailedly. Inspection items are as follows:
1. Before coking and boiling, chain grate should be cold test run again and continuous running time shall not be less than 24 hours.
2. Ignition door can be opened flexibly, coal gate can be lift and dropped conveniently, coal gate left and right side is of the same distance to grate, and ensure the material layer thickness on both sides of the furnace is equal. If distance is not equal, it can be adjust...
As a clean fuel, natural gas has much lower sulfur content and nitrogen content than coal, and there is no ash in the fuel, and the flue gas produced after combustion is almost smoke-free. Therefore, a nationwide upsurge of coal to gas has been set off.
However, there are some problems in the process of gas boiler operation, among which the hardness, harm and treatment of gas boiler flue gas condensate are prominent.
When the boiler flue gas temperature is lower than the dew po...
The main working principle of industry is a kind of heating equipment which uses the heat energy released after fuel combustion or the waste heat in industrial production to transfer to the medium in the container, so that the medium can reach the required temperature, and then it can be transported to the heating process for heat exchange. According to different media, boilers can be divided into many types.
Types of boiler heating medium
1. Steam, steam boiler and superheated steam b...
Precautions for long-term work in the boiler room
1. Standard setting. Nowadays, most boilers are operated by PLC control system. Therefore, when setting, the boiler should be operated according to the factory instructions, so that the boiler can work within the required range.
2. Water level and water quality. Check whether the boiler water supply facilities are normal and whether the boiler water level meets the requirements. In addition, check whether the water quality is up to standard and...
Industrial boiler is an important thermal power equipment, but in recent years, due to large emissions and serious pollution, substandard industrial boilers have become the focus of governance. Biomass pellet boiler is popularized because of its green, low-carbon and clean economy. The thermal efficiency of biomass pellet boiler is related to the economic benefits of enterprises, and users pay special attention to it. What is the thermal efficiency of biomass pellet boiler?
Thermal effi...
Industry boiler is an important thermal power device, which is widely used in factory power, building heating, people's life and other aspects, with a large demand and a wide variety. According to the different flue gas passes, gas-fired boilers are divided into two-pass and three-pass boiler structures. Here, ZOZEN Boiler focuses on the structure and process principle of the common three-pass boiler.
The first pass: after the fuel is atomized by the burner, the formed torch is filled i...
Hot water boiler is a kind of thermal equipment that uses natural gas, oil and biomass as fuel to heat water to the rated temperature. It is widely used for heating, bathing and domestic hot water in hotels, schools, hotels, communities and other enterprises and institutions. Generally, pressurized hot water boiler is widely used, so what does pressure-bearing hot water boiler mean?
In a pressure-bearing hot water boiler, the meaning of pressure is that the internal pressure of the boil...
When the boiler flue gas is saturated wet flue gas, the flue gas contains a large amount of water vapor. At this time, if the flue gas is directly discharged from the chimney and enters the low-temperature ambient air, and the saturated humidity of the ambient air is relatively low, the water vapor in the flue gas will condense to form wet plumes, which is often called "white smoke".
The water in the flue gas of the boiler is produced during the combustion of the hydrogen element of hyd...
