The installation contents of boiler body pipeline are as follows:
1) Connection between water supply console and economizer header;
2) Connection between economizer and inlet pipe from economizer outlet to drum;
3) Connection between the main pipe and branch pipe of the drum drop and each lower header of the water wall;
4) Connection of steam guide pipe between each water wall header and steam drum;
5) Connection of superheated steam pipe between outlet header of low-temperature superheater...
A steam generator is a mechanical equipment that uses the heat energy of fuel or other energy resources to heat water into hot water or steam. It belongs to small equipment and is a kind of steam boiler. According to Boiler Safety Technical Inspection Regulations, a boiler whose water volume exceeds 30 litres belongs to pressure container, national special equipment. There is no need of water storage in the internal structure of modular steam generator concurrent pipeline and the water volume is...
Combustion is a process which needs constant air supply for its survival, but as we move up the earth i.e. at higher altitudes, things aren’t the same as they used to be at sea level. Due to decreased air density at higher altitude, it will consume the same volume of air but will not consume the same mass of air.
This results in less fuel consumption & less steam generation rate. Due to the reduction of mass flow of gases through tubes of a steam boiler, convective heat transf...
Here load means, amount of steam drawn from the boiler. So when the load increases, the specific volume of the steam in the boiler increases reducing the pressure. This inturn demands for more feed water and more amount of fuel to be burnt. So, for any boiler there will be a feed water level control system put in place to measure the water level in drum. As and when the level of water in the drum reduces, the controller sends a signal to the feed water pump to start and stops when the desired water level is reached. This way the steam generation continues to maintain the desired pressure.
Question details (Performance):1. The furnace wall at the coal economizer leaks water and steam with abnormal sound.2. The water level in the boiler drops sharply, and the water supply is obviously greater than the evaporation capacity.3. Smoke exhaust temperature and water outlet temperature rise.Answer: Fault reason:1. The water quality does not reach standard, and the oxygen in the water is decomposed into corroded pipe walls when the temperature rises.2. The low feed water temperature and smoke exhaust temperature make the inner and outer wall of the coal economizer pipe produce acid corrosion, or flying ash wear the pipe wall thin. 3. The pipe is blocked by impurities, causing overheating.4. Poor materials, defects in manufacturing, installation and maintenance. Troubleshooting:1. When economizer is slightly broke, it still maintains boiler operation, and the gap seems will not expand rapidly, in this case, load operation should be reduced, and start the spare boiler immediately,
