Combustion is a process which needs constant air supply for its survival, but as we move up the earth i.e. at higher altitudes, things aren’t the same as they used to be at sea level. Due to decreased air density at higher altitude, it will consume the same volume of air but will not consume the same mass of air.
This results in less fuel consumption & less steam generation rate. Due to the reduction of mass flow of gases through tubes of a steam boiler, convective heat transf...
In addition to water, other fluids can transport heat in industrial boilers, and thermal fluids usually replace water when higher temperatures are needed.
The answer is yes. The bagasse boiler is a distinctive biomass boiler. According to its specific application, it can also be said to be a bagasse biomass power generation boiler. The bagasse boiler is mainly used for power generation, especially large-scale bagasse biomass boiler equipment, such as 75 tons/hour bagasse power generation boiler, 150 tons bagasse boiler, and 180 tons power generation boiler.
The chain grate is the combustion equipment of coal-fired steam boiler. There are three main types and structures: chain belt grate, scale grate and beam grate.
The hot medium oil of the thermal oil heater should be tested regularly to measure and analyze the physical and chemical indicators such as the residual carbon, acid value, viscosity, flash point, melting point and so on, so as to know the quality changes in time and analyze the reasons for the changes. When the acid value exceeds 0.5mgKOH/g, the viscosity change reaches 15%, the flash point change reaches 20%, and the residual carbon (mass fraction) reaches 1.5%, it indicates that the performance of the hot medium oil has changed. Therefore, the user needs to regularly add the new heat carrier when using the hot medium oil to keep the residual carbon in the system stable.
The flue gas first enters the cyclone dust collector which acts as a primary dust collector to make the large dust particles in the flue gas settle down. The cyclone dust collector is a dust removal device which uses the centrifugal force generated by the cyclone flow to separate the dust particles from the air flow. Afterwards, the flue gas enters the wet scrubber dust collector which is a circular-type cylinder. The circulating water enters the dust collector from the upper overflow tank to form a uniform water film on the inner wall of the dust collector. The flue gas is induced tangentially or spirally from the lower part of the cylinder and rotates in the cylinder. Under the influence of the centrifugal force, the dust particles are separated from the flue gas and then the flue gas is also spirally led out from the top of the cylinder. The dust particles are thrown to the water film, transferred to the bottom and finally discharged from the dust port.
Biomass-fired boilers can burn many fuel types, but they all belong to biomass energy, such as corn stalks, wheat straws, straws, peanut shells, corn cobs, cotton stalks, soybean stalks, weeds, branches, leaves, sawdust, bark and other solid waste of wood or furniture factories.
