People assume that owning a biomass boiler is no different from owning its less environmentally friendly cousins, the oil and gas boilers. Nothing could be further from the truth, and it is this very misconception which leads to abuse and neglect of the maintenance that a biomass boiler needs, if it is to retain its environmental and economic saving potential. This is especially true given the tendency of many installers to skimp on providing the proper support services and education to their customers.
One of the biggest issues related to natural gas explosions is that in the industrial world, people just don’t understand that natural gas piping repairs are different from other piping repairs.
Three-pass steam boilers are so-called because the combustion gases that are produced inside them in the burner go round a circuit that has three parts before leaving it:
For a boiler to operate stably and efficiently, all links must be properly coordinated without making mistakes. For gas-fired boilers, it is necessary not only to have softened water treatment facilities, but also to carry out regular sewage discharge, which cannot be ignored.
For an industrial boiler with reasonable structural design, its thermal efficiency is relatively high, and its exhaust gas discharge temperature is relatively low, so we must carefully consider the boiler property report form when purchasing the boiler.
According to the differences in fuel and structure, industrial thermal oil heaters are mainly divided into the oil/gas-fired thermal oil heater and coal/biomass-fired thermal oil heater. The basic configurations of the thermal oil boiler system generally are as follows.
The flue gas first enters the cyclone dust collector which acts as a primary dust collector to make the large dust particles in the flue gas settle down. The cyclone dust collector is a dust removal device which uses the centrifugal force generated by the cyclone flow to separate the dust particles from the air flow. Afterwards, the flue gas enters the wet scrubber dust collector which is a circular-type cylinder. The circulating water enters the dust collector from the upper overflow tank to form a uniform water film on the inner wall of the dust collector. The flue gas is induced tangentially or spirally from the lower part of the cylinder and rotates in the cylinder. Under the influence of the centrifugal force, the dust particles are separated from the flue gas and then the flue gas is also spirally led out from the top of the cylinder. The dust particles are thrown to the water film, transferred to the bottom and finally discharged from the dust port.
Boiler is a piece of equipment with large energy consumption. Therefore, both boiler manufacturers and purchasers regard energy conservation as an important indicator of boiler performance. The daily energy-saving measures of the natural gas fired boiler are mainly as follows.
