What are the precautions for using gas-fired hot water boilers?

The correct use of gas-fired hot water boilers can avoid a series of unnecessary hazards to ensure the safety of boiler operation and the safety of personnel. Today, I will introduce the three major precautions for using a professional gas hot water boiler to help you better use the gas hot water boiler.

Precautions for gas-fired hot water boilers

1, pay attention to the way of water

The water feeding method is an important way to ensure the safe operation of the hot water boiler. When adding water, it is necessary to close the inlet valve of the return pipe, and then turn on the circulating water pump to adjust the water pressure to a suitable range before starting to inject clean water. After the system is filled with water, the water level of the boiler is adjusted to the normal condition, which can ensure that the performance of the gas-fired hot water boiler can be fully exerted.

2, pay attention to the inspection before ignition

Before ignition, each auxiliary equipment of the boiler must be checked, and special attention should be paid to whether the valve is opened reliably, so as to ensure the smooth circulation of water inside the boiler and avoid excessive pressure caused by steam blockage. If it is found that the closing valve leaks seriously during the inspection, it should be repaired or replaced in time and cannot be ignited rashly.

3, Pay attention to cleaning the sundries in the water tank

When the tank is used for a long time, some debris may settle out, which may damage the pump and block the valve. Before using a gas-fired hot water boiler, it is necessary to check whether there are deposits in the water tank and clean it up in time, so as to ensure a better heating effect and avoid the danger of high temperature and high pressure inside the boiler.

If the gas hot water boiler is in use, if the valve is blocked, it may cause the internal pressure of the gas hot water boiler to soar. When using it, you must pay attention to the water supply method, check the deposition problem inside the boiler, and perform pre-ignition inspection. These three points can ensure the normal operation of the gas hot water boiler.

ZOZEN automatic hot water boiler

Aside from the day-to-day considerations, a more straightforward way to ensure efficient heating from your boiler is to purchase a reliable gas-fired hot water boiler system. As a leader among the manufacturers of condensing gas-fired hot water boilers, ZOZEN boilers use advanced combustion methods to ensure full combustion of fuel, sufficient output of the boiler system and high thermal efficiency; automated control and monitoring systems make the operation easier Reasonable, not only the operation and maintenance cost of the boiler is low, but also the service life becomes longer, and the safety and reliability of the boiler operation are guaranteed.

1. Waste heat recovery: The exhaust gas temperature of gas-fired hot water boilers is relatively high. ZOZEN adopts the method of increasing the heating surface at the rear to reduce the exhaust gas temperature of the boiler or to recover the sewage and condensate water of the boiler, so as to achieve the purpose of energy saving.

2. Water quality control: ZOZEN gas-fired hot water boiler is reasonably equipped with feed water treatment, which greatly controls the water quality of the boiler feed water, prevents the boiler from scaling, and enables the boiler to operate without scale or thin scale.

3. Automatic operation: automatic load adjustment, combustion adjustment, etc., make the gas-fired hot water boiler in a better economic operation state, so as to achieve the purpose of energy saving.