coal fired steam boiler with european, ZOZEN gas-fired steam boiler assists the brewing enterprises to enter the era of standardization and planning

Winter is officially here! When cold weather settles in, it is important to make sure that your boiler is well-maintained. Like any other mechanical system, boilers will tend to wear down over time. Boilers can be dangerous if not properly inspected and not working properly. Full boiler efficiency will help avoid boiler downtime and unnecessary expenses. Here are 14 steps to follow to help you get on track with your winter maintenance.

In June of 2020, according to the development strategy of overseas market, ZOZEN Boiler made a in-depth communication and negotiation with ESCOM in Mexico and two sides reached an agreement on the cooperation details.

The SZL series biomass-fired chain grate boiler is safe and efficient with a capacity of 4-35 tph (hot water boiler: 2.8-29MW) and a thermal efficiency of over 88%. By extending the furnace arch, increasing the furnace height and adjusting the width and length of grate, ZOZEN takes the lead in solving the problems that easily occur in biomass-fired boilers such as furnace arch collapse, furnace door burnout, hopper tempering and tube wall coking. It has the characteristics of wide fuel adaptability, small covering area, convenient installation and high thermal efficiency, coal fired steam boiler with european.

WNS series and SZS series steam boilers, as the hot-selling eco-friendly gas-fired boiler products of ZOZEN Boiler, replace the coal-fired boilers with high pollution, and become the common choice of many enterprises in the pharmaceutical and chemical industries in Yunnan Province. ZOZEN boiler is equipped with advanced low-NOx burner to ensure the low NOx emissions, coal fired steam boiler with european.

ZOZEN SZS series boiler body is designed with D-type chamber combustion structure. The furnace is on right side and the convection heating surface is on left side. The membrane type structure is adopted for the circumference of the furnace body, the wall between the furnace and the convection zone, the front and rear walls of boilers body. The furnace pressure is designed to be greater than 6000Pa.

ZOZEN Boiler has set up seven process stop points that are material re-inspection, material inspection number transfer, plate welding test, heat treatment, pre-expansion before welding, flaw detection inspection, hydrostatic test, which are inspected by seven responsible engineers. If any link is unqualified, it will not be able to proceed to the next process, which ensures that each ZOZEN boiler has the high quality.

In recent days, ZOZEN YLW thermal oil heater was successfully shipped. It could be put into operation immediately by simply switching on the power. The easy installation will help Kay & Emms save a lot of installation cost.