The primary purpose of the boiler is to supply energy to the facility's operations – for comfort heating, manufacturing process, laundry, kitchen, etc. The nature of the facility's operation will dictate whether a steam or hot water boiler should be used. Hot water is commonly used in heating applications, with the boiler supplying water to the system at 120°F to 220°F. The operating pressure for hot water heating systems usually is 30 psig to 125 psig (hydrostatic). Under these conditions, there is a wide range of hot water boiler products available. If system requirements are for hot water of more than 250°F, a high-temperature water boiler should be considered.
In order to improve the combustion efficiency of the boiler, in a large boiler, the combustion air is not supplied all at once, but is supplied in two times, one is supplied with the fuel that controls the rate of combustion as well as the amount of fuel that can be burned,and the other is directly supplied to the combustion process that that improves combustion efficiency. The primary air rate of the boiler refers to the proportion of the primary air. If the total air volume is 100% and the primary air rate is 70%, the secondary air rate is 30%.
The steam drum wall in a boiler refers to the wall of the steam drum, which is one of the important components of the boiler. The steam drum wall is generally made of corrosion-resistant alloy steel plates under high temperature and pressure, and has high strength and corrosion resistance.
The steam drum is an important component in the boiler and mainly acts as a buffer between steam and liquid water. When water enters the steam drum from the pipeline, it turns into steam and accumulates at th...
A firetube boiler can react very quickly to load changes due to the fact that it has a large volume of stored energy in the form of hot water and steam.
Boiler is a kind of thermal energy conversion equipment composed of drum and furnace. It uses fuel combustion to heat water into steam or hot water to provide power for production or help auxiliary production. With the continuous improvement of industrial manufacturing technology, boiler's control has also changed from the traditional full manual operation to the present automatic intelligent control.
A well designed and operated biomass boiler burning fuel within the specification of the boiler should not produce any smoke, but black smoke may be produced if the fuel is too wet for the boiler. All biomass boilers produce some oxides of nitrogen (NOx), particularly nitrogen dioxide (NO2). While NOx emissions from gas boilers have been reduced significantly in recent years through the use of low NOx burners which burn at a temperature slightly below that at which NOx forms, the nature of biomass combustion, and the need to ensure the complete combustion of wood gases, means that combustion takes place at a temperature where atmospheric oxygen and nitrogen can chemically combine. The better the quality of the combustion control system on a biomass boiler, the lower the NOx emissions will be. In general, biomass boilers produce less NOx than oil boilers. Biomass boilers do not produce any oxides of sulphur (SOx).
In the whole drying process, we should pay attention to gradually increasing the temperature instead of burning by raging fire; regularly checking boiler's water level and keeping it within the normal range; keeping the flame balanced in the furnace. In addition, we also should properly open the drainage valve and maintain the water level, regularly record the flue gas temperature to control the rise of temperature and high temperature and keep the temperature within the normal range. In general, under these conditions, boiler’s drying quality can be ensured.
The coal-fired boiler has always been one of the important boiler types in the industrial production and its operating costs and capacity play an important role in the enterprise operation.
