boiler capacity, ZOZEN boiler leaps to become the industry benchmark

The primary purpose of the boiler is to supply energy to the facility's operations – for comfort heating, manufacturing process, laundry, kitchen, etc. The nature of the facility's operation will dictate whether a steam or hot water boiler should be used. Hot water is commonly used in heating applications. Under these conditions, there is a wide range of ZOZEN hot water boiler products available.

Under the background of increasingly fierce market competition and rising comprehensive costs, Mengniu Dairy always adheres to the concept of sustainable development. When purchasing boiler equipment, it uses clean energy natural gas as fuel to reduce environmental pollution. So far, Mengniu Dairy has purchased more than ten sets of WNS series gas-fired steam boilers from ZOZEN.

ZOZEN YLW series thermal oil heater is of square coil tube vertical type chain grate, it consists of two separate parts - chain grate stoker and heater body. After erection on site, it only needs to connect to thermal oil piping and electricity to start operation. The heater adopts chain grate to perform mechanical fuel feeding, equipped with FD fan and ID fan for air ventilation, and also equipped with slay discharger to remove the bottom slag, boiler caacity.

Recently, ZOZEN YQW series thermal oil heaters gained favor of SOTRATECH in Mauritius, which is an energy company engaged in utilization and development of sustainable energy. This time SOTRATECH wanted to purchase one thermal oil heater for a local textile mill, providing heat energy for dying, printing, drying and other production progresses. The director of SOTRATECH said that ZOZEN thermal oil heater featured advanced production technology and strict quality test standards, then he ordered a set of 2.8MW YQW series gas-fired thermal oil heater from ZOZEN.

ZOZEN WNS series gas fired boiler not only adopts advanced low NOx burners. And through the flue gas recirculation technology, about 10% -30% of the flue gas at the tail of the boiler is sucked into the air inlet of the burner through the flue gas pipe, mixed with the combustion-supporting air, and then entering the furnace, thereby reducing the temperature and oxygen concentration in the combustion area, and finally reducing The amount of thermal NOx is generated, and the NOx in the tail gas of the boiler are less than 30mg/Nm3, which meets the requirements of low nitrogen emissions of the enterprise.enterprise, boiler caacity.

ZOZEN X-ray flaw detection is a non-destructive testing method

Moreover, ZOZEN professionals provide full guidance from the installation and the trial operation of the boiler to the training of the boiler operator, so that each user can enjoy one-stop worry-free service from pre-sales to after-sales.