Every customer is concerned about the service life of products he purchases. Extending the service life of thermal oil heater is helpful for reducing customer’s costs and increasing profits. Different existing thermal oil heaters on the market have different service years.
According to the differences in fuel and structure, industrial thermal oil heaters are mainly divided into the oil/gas-fired thermal oil heater and coal/biomass-fired thermal oil heater. The basic configurations of the thermal oil boiler system generally are as follows.
Question details (Performance):1. High temperature of motor, fast temperature rise.2. Overload, high outlet pressure and frequent safety valve open often.3. The vibration is intensified, the side vibration of the fan motor coupling is large, and the fan body never vibrates to vibration.4. No obvious vibration was found in no-load test of fan motor. Answer: Fault reason:Fan bearing vibration is common fault in the operation, the vibration of the fan will cause damage of bearing and blade, bolt looseness, chassis and wind damage, fan vibration rises abruptly in the operation. this is because when the gas enter impeller and the rotating blade working face has certain angle, according to the principle of fluid mechanics, gas from non-working face must be a spiral blade, so the dust particles in the gas will slowly sedimentation due to vortex. Airfoil blades are very easy to accumulate dust. When the accumulated ash reaches a certain weight, a part of the large amount of accumulated ash wi
Specific performance:Low level alarm of expansion tank.Answer：Cause of failure:The pipeline system (including heater) has not been replenished in time after oil leakage or degassing. Troubleshooting:Eliminate system defects and add oil.
Dealing with abnormalities in the circulating pump of a thermal oil heater involves several steps, aimed at identifying the issue and applying the appropriate corrective measures. Here’s a general approach:
1. Identify the Symptom: Common abnormalities include unusual noises, overheating, reduced flow rate, leakage, or vibration. Understanding the symptom helps in pinpointing the underlying issue.
2. Check Electrical Components: Inspect electrical connections, fuses, and the motor for an...
During the ignition and operation of the chamber combustion boiler fueled by pulverized coal, oil or combustible gas, improper operation can cause the deflagration or secondary combustion in the furnace or flue gas duct, which can further cause the increased pressure in the furnace. When the pressure reaches a certain value, the explosion-proof door is necessary to open automatically to protect the furnace wall of the boiler.
A well designed and operated biomass boiler burning fuel within the specification of the boiler should not produce any smoke, but black smoke may be produced if the fuel is too wet for the boiler. All biomass boilers produce some oxides of nitrogen (NOx), particularly nitrogen dioxide (NO2). While NOx emissions from gas boilers have been reduced significantly in recent years through the use of low NOx burners which burn at a temperature slightly below that at which NOx forms, the nature of biomass combustion, and the need to ensure the complete combustion of wood gases, means that combustion takes place at a temperature where atmospheric oxygen and nitrogen can chemically combine. The better the quality of the combustion control system on a biomass boiler, the lower the NOx emissions will be. In general, biomass boilers produce less NOx than oil boilers. Biomass boilers do not produce any oxides of sulphur (SOx).
