1) The entire plant may be purchased as a complete package, only needing securing to basic foundations, and connecting to water, electricity, fuel and steam systems before commissioning. This means that installation costs are minimised.
2) This package arrangement also means that it is simple to relocate a packaged shell boiler.
3) A shell boiler contains a substantial amount of water at saturation temperature, and hence has a substantial amount of stored energy which can be called upon to cope with short term, rapidly applied loads.
*This can also be a disadvantage in that when the energy in the stored water is used, it may take some time before the reserve is built up again.
4)The construction of a shell boiler is generally straight forward, which means that maintenance is simple.
5)Shell boilers often have one furnace tube and burner. This means that control systems are fairly simple.
Although shell boilers may be designed and built to operate up to 27 bar, the majority operat
Every customer is concerned about the service life of products he purchases. Extending the service life of thermal oil heater is helpful for reducing customer’s costs and increasing profits. Different existing thermal oil heaters on the market have different service years.
According to the differences in fuel and structure, industrial thermal oil heaters are mainly divided into the oil/gas-fired thermal oil heater and coal/biomass-fired thermal oil heater. The basic configurations of the thermal oil boiler system generally are as follows.
Selecting a gas-fired boiler for heating a 200,000 m^2 area involves several considerations to ensure efficient, reliable, and cost-effective operation. Here’s a structured approach:
1. Determine Heating Demand
First, calculate the total heating demand of the 200,000 m^2 area. Heating demand varies based on climate, building insulation, usage, and local standards. A rough estimate for moderate climates is 100 W/m^2, but this can vary.
2. Choose Boiler Type
Decide on the boiler type. Fo...
A well designed and operated biomass boiler burning fuel within the specification of the boiler should not produce any smoke, but black smoke may be produced if the fuel is too wet for the boiler. All biomass boilers produce some oxides of nitrogen (NOx), particularly nitrogen dioxide (NO2). While NOx emissions from gas boilers have been reduced significantly in recent years through the use of low NOx burners which burn at a temperature slightly below that at which NOx forms, the nature of biomass combustion, and the need to ensure the complete combustion of wood gases, means that combustion takes place at a temperature where atmospheric oxygen and nitrogen can chemically combine. The better the quality of the combustion control system on a biomass boiler, the lower the NOx emissions will be. In general, biomass boilers produce less NOx than oil boilers. Biomass boilers do not produce any oxides of sulphur (SOx).
The slag produced by a biomass-fired boiler can be reused to avoid energy waste and environmental pollution. There are many ways to reuse the slag. For example, the slag can be used to improve soil and improve soil performance. If it contains potassium carbonate and organic matter, it can also be used to produce compound fertilizers. In addition, the slag is a kind of plant ash, it is also a good thermal insulation material for steelmaking.
After combustion, biomass-fired boiler fuel will generate energy and also produce some combustible matter in fly ash which will have bad influence on the surrounding environment. Therefore, in order to realize the goal of environmental protection, we should reduce the generation of combustible matter in fly ash in biomass-fired boiler fuel.
The pollution discharge of the biomass-fired boiler is less than the coal-fired boiler. It is also necessary to deal with the exhaust gas of the biomass-fired boiler to meet the national standards before boiler ignition and operation.
