If the pumps of a coal-fired boiler are not absorbing water, it could be due to several reasons. It's essential to diagnose the issue accurately for an effective solution. Here are some common causes:
Air Locks in the Pump or Suction Line: If there is trapped air within the pump or the suction line, it can prevent the pump from creating the necessary vacuum to draw water.
Low Water Level in the Feed Tank: If the water level in the feed tank is too low, the pump may not have enough water to dra...
(Question details) specific performance:The gas boiler is powered on, press start, the motor does not turn. Answer: Fault reason:1. Insufficient pneumatic locking.2. The solenoid valve is not sealing, and there is air leakage at the joint. Check the lock.3. The thermal relay is open.4. At least one of the conditional circuits is not valid (water level, pressure, temperature and to check whether the program controller is energized to start). Troubleshooting:1. Adjust the air pressure to the requested value.2. Clean or repair solenoid valve pipe joint.3. Check whether the component is damaged and motor current by reset.4. Check whether the water level, pressure and temperature exceed the limit.ZOZEN gas-fired boiler adopts automatic control to control the operation, combustion, water level, temperature and steam pressure. In case of such problems, the system will automatically prompt the error code.
Using artificially softened water in the heating circuit with your boiler can potentially cause issues and is not recommended.
Artificially softened water contains high levels of sodium ions, which can cause corrosion of the boiler and other components in the heating system. This corrosion can damage the boiler and other components, leading to leaks and reduced efficiency.
In addition, artificially softened water can cause problems with water pressure and flow rate, which can i...
Manually close the fuel supply valve, stop the combustion, purge after the program enters, until the end of the purge, stop the program such as burning heavy oil, and enter the line sweeping stage before stopping the combustion, and purge with steam or light oil pipe; Generally, steam purging is used when stopping for a long time.
Generally, it is required that the water temperature shall be reduced to 80℃ to drain the water in the boiler. This is because if the water temperature is high, the temperature in the furnace is still very high, and the metal of the furnace wall and heating surface will still accumulate some heat. After the water is released, there is no working medium in the water wall to cool, which makes the wall temperature rise and the temperature rise is uneven, which is not conducive to the safety of the water wall.
The installation contents of boiler body pipeline are as follows:
1) Connection between water supply console and economizer header;
2) Connection between economizer and inlet pipe from economizer outlet to drum;
3) Connection between the main pipe and branch pipe of the drum drop and each lower header of the water wall;
4) Connection of steam guide pipe between each water wall header and steam drum;
5) Connection of superheated steam pipe between outlet header of low-temperature superheater...
Generally, small gas-fired hot water boilers are between 0.7 MW and 14 MW, and the output of boilers is different, so the prices are different. Different pressures require different techniques, materials and pressures. The higher the pressure, the higher the price.
New energy boiler fuel is a new clean and environmentally friendly fuel product. The fuel of new energy boiler is clean, sanitary, green and environmentally-friendly. No "three wastes" such as waste gas, wastewater and waste residue are discharged in the production process. It has high oxygen content, full incineration, no black smoke, no carbon deposit, no boiler black bottom, no residual liquid or residue. The waste gas from incineration is more than 80% lower than that of LPG.
